Driveway & pavers
Kitchen remodeling
Bathroom remodeling
Home additions & ADU
Roofing
Windows & doors
FenceFree written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
See the difference
Before
After
Before
After
Before
AfterHow to Fix a Sinking Driveway in Los Angeles (and Why Most Quick Fixes Fail Here)
A sinking driveway in Los Angeles is usually caused by expansive clay soil swelling and shrinking through the drought-and-rain cycle, or by drainage and slope problems on a graded hillside lot. The durable fix is almost never a surface patch or foam injection on its own: it means stabilizing the subgrade and correcting the grading and drainage that let water get under the slab in the first place. Mudjacking or slab lift will buy you a season or two, then the same section drops again. Only an on-site evaluation tells you which root cause you’re dealing with. Call (888) 427-1733 to set that up.
Here’s the part that catches homeowners off guard. The answer you get from a national how-to video was probably written for a place with stable, sandy ground. LA isn’t that place. The ground moves, the hills shed water, and after a fire season the soil itself changes how it takes on water. Fix a driveway here without understanding which of those forces is at work and you’ll be fixing it again.
Why a sinking driveway in Los Angeles isn’t like a sinking driveway elsewhere
Los Angeles sits on some of the most expansive clay soil in the American West. Over the San Fernando Valley, large stretches of South LA, and the foothill edges, those silty clays can shift 2 to 4 inches seasonally. A wet winter after a run of dry years is when the movement gets dramatic. The ground swells, then dries and contracts, and the slab riding on top of it moves with it. Concrete and pavers flex a little. They don’t flex that much.
That’s why the generic SERP answer – mudjack, foam, or tear it out – keeps coming up short around here. Any repair that doesn’t address the soil beneath the slab is a bet against the next wet season. Proper base recompaction and subgrade stabilization aren’t upsells in this market. They’re the difference between a repair that holds and a repair that re-sinks.
Hillside driveways fail for a completely different reason, and the two get confused constantly. In the Hollywood Hills and the Santa Monica Mountains, a sloping driveway that starts dropping is often telling you about slope creep and poor drainage, not soil expansion. Water runs under the slab, the hillside grade slowly gives, and the pavement follows. Surface repair alone does nothing for that. Those driveways need regrading and a French drain or a comparable drainage strategy before anyone touches the pavement.
The local scenarios we run into most
These are the versions of “my driveway is sinking” that show up most often in Los Angeles:
- Flat-lot Valley driveways cracking and dropping at the garage apron. Expansive clay cycling through wet and dry seasons. The apron and the first few feet of slab take the worst of it.
- Hillside driveways in the Santa Monica Mountains and Hollywood Hills. Slope creep and water running under the pavement. These need drainage and grading work, not foam.
- Homes downslope from a recent burn scar. Post-wildfire soil can turn hydrophobic and repel water at first, then absorb it in a rush, carving voids under driveways below. That’s a soil-assessment situation before anything else happens.
- Driveways that sink along a settling garage or addition. Often tied to how the original site was graded and compacted, and worth looking at alongside the broader scope of the property rather than the slab alone.
Post-fire soil is the one most homeowners don’t see coming. On a burn scar, the baked top layer initially refuses water, and runoff sheets hard into whatever’s downhill. Once that layer breaks down, the soil takes on water fast and unevenly, and driveways below can suddenly have voids underneath them. If you’re anywhere near a recent fire zone, a soil assessment belongs before any slab lift, full stop.
What the fix actually involves (and what we check before quoting)
There’s a real sequence to getting this right, and it starts with diagnosis:
- Drainage evaluation. Where does water go when it rains? Roof downspouts, yard slope, grading at the garage apron, and any French drain or swale all get checked.
- Subgrade assessment. What’s under the slab, how compacted is it, and is the soil the expansive stuff or something more stable?
- Root-cause repair. Subgrade stabilization and correct drainage before the surface goes back down.
- Surface rebuild. New base, proper compaction, then the pavers or concrete.
One LA reality that generic how-to pages skip: if the sinking traces back to a grading failure on a hillside lot, any repair that touches the grade can require a grading permit and a soils report under LAMC Title 26. Projects that dig deep enough to reach foundations or hillside cut-and-fill areas can bring in seismic and hillside grading review, the same body of rules that governs the region’s soft-story retrofits and hillside building. Pulling the right permits protects you at resale and keeps the work reviewable. Skipping them is how a driveway repair turns into a problem when you sell.
That’s the reason our background-checked technicians conduct an on-site drainage and subgrade evaluation before quoting instead of eyeballing the slab from the curb. The upfront price you get accounts for the actual root cause, not just the visible symptom. And it’s covered by the 730-Day Done Right Promise – if it re-sinks, we’re on it.
When the diagnosis calls for a full surface replacement rather than a lift, the cost in Los Angeles runs in a fairly recognizable band:
| Driveway service | Typical Los Angeles range |
|---|---|
| Paver driveway installation | $8,260-$21,240 |
| Concrete driveway installation | $5,310-$14,160 |
| Asphalt driveway paving | $4,130-$10,620 |
| Driveway replacement | $5,900-$16,520 |
| Driveway sealing | $295-$825 |
Those ranges assume the subgrade and drainage are handled. Skipping that step can look cheaper up front and costs more the second time around. If you’re leaning toward replacing the surface anyway, it’s worth thinking through materials at the same time – we lean on brands like Tremron, Techo-Bloc, and Cambridge Pavers when the job calls for pavers, because the base work and the surface need to hold together as one system. The full scope of options lives on our Driveway & Pavers page.
Repair or replace? How to tell in Los Angeles
A driveway with one settled section on otherwise sound concrete is often a candidate for targeted repair and lift once the soil issue is addressed. A driveway with widespread cracking, multiple settled areas, or a failing garage apron usually needs replacement along with the underlying fix. The deciding factor in Los Angeles is almost always what’s happening under the slab, not how the surface looks. A single low spot after a wet winter is a different problem from a slab that’s been dropping for several seasons.
Sealing won’t fix a sinking driveway. It protects a healthy surface from water intrusion and sun, which is worth doing on a driveway that’s in good shape, but it does nothing structural. If the slab is already moving, sealing it just hides the symptom.
Frequently asked questions
Foam injection can lift a settled slab, but on LA’s expansive clay it usually only holds for a season or two if the soil and drainage haven’t been addressed. It works best as part of a repair that also stabilizes the subgrade and corrects the water problem underneath. On hillside driveways with slope creep, foam alone is the wrong tool entirely. Call (888) 427-1733 for an honest read on whether a lift will actually hold.
Concrete driveway installation in Los Angeles typically runs $5,310-$14,160, and paver driveways run $8,260-$21,240, depending on size and how much subgrade and drainage work is involved. A targeted repair on a single settled section can come in well under a full replacement. The number depends on what’s actually causing the sinking, which is why we evaluate it on-site before quoting. Estimates are free – call (888) 427-1733.
Sometimes. If the sinking traces to a grading problem on a hillside lot, a repair that touches the grade can require a grading permit and a soils report under LAMC Title 26. Surface-level fixes usually don’t. We’ll tell you upfront whether your job needs one. Call (888) 427-1733 and we’ll walk through what applies to your property.
The short answer: it takes an on-site look. Flat-lot driveways in the Valley on expansive clay usually point to soil movement, while hillside driveways in the Hollywood Hills more often point to slope creep and drainage. Post-fire zones add a third cause – hydrophobic soil and voids. A drainage and subgrade evaluation sorts it out, and we do that before quoting. Call (888) 427-1733 to schedule one.
If you’d rather have it looked at than guess, Groundwork Construction Co. of Los Angeles offers a no-pressure assessment in Los Angeles. We evaluate the drainage and subgrade first, quote the root cause, and back the work with our 730-Day Done Right Promise. Call (888) 427-1733 for a free estimate.
Written by the team at Groundwork Construction Co. of Los Angeles, serving Los Angeles, CA.