Kitchen remodeling
Bathroom remodeling
Home additions & ADU
Roofing
Windows & doors
Driveway & pavers
FenceFree written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
See the difference
Before
After
Before
After
Before
AfterPaver Installers Near Me in Los Angeles: What Actually Keeps a Driveway From Settling
If you’re searching “paver installers near me” in Los Angeles, the answer-first version is this: the right installer specs a driveway base differently than a patio base, and that single decision determines whether your pavers look tight in year five or rattle loose by year two. Our crews at Groundwork Construction Co. of Los Angeles build vehicle-load paver driveways on a 6 to 8 inch compacted base, not the 4 inch landscape bed that shows up in most Spanish Colonial and postwar tract home driveways across the flats. Call (888) 427-1733 and we’ll walk your driveway and tell you what’s under it before anyone quotes a number.
Why the Base Is the Whole Ballgame on Los Angeles Clay
The most common paver failure we see in Los Angeles isn’t the paver itself. It’s the base, or the lack of one. A landscape crew that sets a beautiful back patio will often use the same 1 inch sand bed over 4 inches of base for a driveway that parks two SUVs every night. Patio pavers only ever hold foot traffic and a grill. A driveway holds 4,000 to 5,000 pounds per axle, plus the point loads of jack stands and ramps. On the expansive clay soils that run through the flats of Los Angeles, that mismatch shows up as ridging, rutting along the wheel paths, and lips at the joints within 18 months.
Here’s the honest specification we build to for a vehicular driveway in Los Angeles:
- Minimum 6 inches of Class II base (8 inches where soil is especially plastic or the subgrade is soft), compacted in 2 inch lifts to 95% Modified Proctor density.
- Geotextile separation fabric between subgrade and base on expansive clay. This stops the clay from pumping up into the aggregate and stops the base from working its way down. Almost no “near me” result mentions it.
- Edge restraints staked at closer intervals than the manufacturer’s minimum. On clay, a paver border without proper edging will push out within 2 to 3 seasonal wet-dry cycles and the entire field migrates with it.
- UV-stable, high-compressive-strength pavers rated for vehicular traffic, not whatever the local distributor had on the yard that week.
That edge restraint point matters more in Los Angeles than most installers admit. Our wet winters followed by long dry summers swell and shrink the clay, and it’s the border that takes the first hit. When the edging lets go, the whole field starts to walk. You see it as widening joints and a driveway that suddenly drains toward the house instead of the street.
What It Costs to Install Pavers Here
Upfront pricing on a paver driveway in Los Angeles lands between $8,260 and $21,240 for most single-family driveways, and the spread is almost always base depth, removal of the old surface, and drainage. A paver patio runs $4,130 to $12,980. When a bid comes in far under the range, the first thing we ask is how many inches of compacted base is in the quote.
| Scope | Typical Los Angeles Range |
|---|---|
| Paver driveway installation | $8,260 - $21,240 |
| Paver patio installation | $4,130 - $12,980 |
| Driveway replacement (full tear-out) | $5,900 - $16,520 |
| Driveway sealing | $295 - $825 |
Compare that against a concrete driveway at $5,310 to $14,160. Pavers cost more up front because the base and edging work is heavier. What you get back is a surface you can lift and re-set a settled section of without demolishing the whole slab. See our full Driveway & Pavers service for the broader scope.
Permeable Pavers and LA’s Stormwater Rules
Permeable paver systems deserve a real look in Los Angeles, and they’re badly underused. The City’s Low Impact Development (LID) stormwater standards reward on-site infiltration, and a permeable paver driveway with an open-graded base can help a project meet that standard while it does something else useful: it breaks up the heat that the LA basin’s asphalt and concrete surfaces trap all summer. A permeable driveway reads cooler underfoot and sheds winter rain into the ground instead of the gutter. If your project touches grading or drainage, this is worth raising before the design is locked.
The seismic and fire code that governs so much Los Angeles construction, from the Soft-Story Retrofit Ordinance in Koreatown and the Valley to hillside grading rules in the Santa Monica Mountains, doesn’t usually touch a flat driveway. But drainage and grading do, and on any sloped lot or hillside property the paver base has to be engineered around where the water goes, not on top of it.
Materials We’ll Actually Put in Your Driveway
We install from a curated portfolio of premium paver brands, the same material rigor that runs through every trade we work in, from KraftMaid and Cambria in kitchens to GAF and Owens Corning on roofs. For driveways, that means confirmed compressive strength ratings and UV-stable pigments, brands like Belgard alongside hardscape lines from Boral, plus IKO and Atlas where a project wraps paving against a roofline or wall. We choose the paver for the load and the color for the sun, not for what’s cheapest on the pallet.
Common Local Scenarios We See in Los Angeles
Spanish Colonial and Craftsman bungalows on the flats. These 1920s to 1940s homes often have a narrow single-car approach, a tight apron at the sidewalk, and mature ficus roots pushing up from underneath. The old concrete is cracked and the subgrade is shot. We tear out, address the root situation or reroute around it, and rebuild the base properly.
1950s and 1960s stucco tract homes. Wider driveways, flatter lots, but original subgrade that was never compacted for modern loads. These are the drives most likely to have been patched and re-patched with cold mix over the years. A full replacement with a compacted Class II base ends the cycle.
Hillside properties in the Hollywood Hills and Santa Monica Mountains. Here the driveway is a retaining structure as much as a parking surface. Slope drainage and geogrid reinforcement come before any paver goes down.
Dingbats and multi-family driveways in Koreatown and the Valley. Tuck-under parking and shared approaches see heavy daily traffic from multiple vehicles, and a permeable system or upgraded base depth makes the difference between a surface that holds for a decade and one that fails in three years.
Why a Live Person on the Line Matters on Install Day
Driveway work is where surprises live. You pull the old surface and find a drainage condition nobody saw coming, or the subgrade turns out to be fill, or a morning rain rolls through with an open base. Our calls are answered by a live person, 24 hours a day, 7 days a week. If your crew hits an unexpected drainage problem at 6am on install day, someone at Groundwork makes the call and keeps the job moving. No voicemail. No waiting until Monday. No open base sitting in the rain.
Our technicians have up to 12 years of experience, they’re background-checked and arrive in uniform, and every project is covered by the 730-Day Done Right Promise. If it’s not done right, we make it right, in writing, for two full years. Upfront pricing means the number you see is the number you pay, and standing offers include $1,000 off projects over $10,000 and 0% financing for 18 months. Every quote starts with a free estimate and design consult.
FAQs
Most paver driveway installs in Los Angeles run $8,260 to $21,240, and paver patios run $4,130 to $12,980. The biggest variables are base depth, removal of the existing surface, and drainage work. Call (888) 427-1733 for an exact quote on your driveway, and the estimate is free.
A vehicular paver driveway in Los Angeles needs a minimum 6 inches of Class II base compacted to 95% Modified Proctor, with 8 inches where the clay is especially expansive. A 4 inch landscape base is fine for a patio and not enough for a driveway. We use geotextile fabric on clay soils to keep the base separated from the subgrade.
Yes, when the base, geotextile layer, and edge restraints are built for the soil. Most settling we see comes from a base that is too thin or edging that isn’t staked tightly enough for clay’s seasonal swell and shrink. Our team will inspect your existing subgrade and tell you exactly what’s needed.
We schedule free estimates throughout Los Angeles, and our line is answered by a live person 24 hours a day. Call (888) 427-1733 and we’ll set a time, whether you’re in the flats of the city or up in the hills.
Get Your Driveway Priced Right the First Time
Don’t let a 4 inch base cost you a driveway. Groundwork Construction Co. of Los Angeles builds paver driveways to the spec Los Angeles clay actually demands, backed by the 730-Day Done Right Promise and upfront pricing with no surprises. Call (888) 427-1733 for a free estimate and design consult, or explore our home page to see every trade we cover.
Written by the team at Groundwork Construction Co. of Los Angeles, serving Los Angeles, CA.
What Our Customers Say
"Change orders were written down and priced before the work happened, every single time. No surprise at the end."
- Keisha Robinson"The finished work is exactly what we wanted. It did run about three weeks over, mostly waiting on a cabinet delivery that was out of his hands, though I would have liked more updates during that stretch."
- Dev Sharma"He pulled the permits himself, scheduled every sub and ran the inspections. I made one decision a week and otherwise stayed out of it, which is exactly what I was paying for."
- Robert Sullivan