A Groundwork company - serving Los Angeles, CA

Barrette Roofing in Los Angeles, CA

RoofingRoofing
Kitchen remodelingKitchen remodeling
Bathroom remodelingBathroom remodeling
Home additions & ADUHome additions & ADU
Windows & doorsWindows & doors
Driveway & paversDriveway & pavers
FenceFence
Every visit starts with

Free written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled

We have financing partners for your dream remodel*On approved credit; ask us about your options
Get your free estimate

Barrette Roofing: The Los Angeles Owner’s Guide

We install and repair Barrette roofing and roof components across Los Angeles, and most Barrette roof repairs run $470 to $2,125, with full replacements landing between $9,440 and $23,600. If you’re reading this because a piece failed, you’re in the right place; we’ll walk you through matching the exact part to your system and what it costs to put it right.

Call (888) 427-1733

Owners usually spot the problem after a rain event. A ceiling stain appears in a hallway below the roofline, or a loose or cracked piece shows up after a Santa Ana wind. Sometimes it’s simpler: a contractor on another job points at a chunk of trim or upstand and tells you it’s failed. Whatever brought you here, the fix is almost always a specific replacement part matched to what’s on your roof, not a full tear-off. We work as an independent service provider and are not affiliated with Barrette.

Which Barrette Models This Applies To

Barrette roof products show up in a few forms, and getting the match right is where most homeowners get stuck. Barrette makes metal roof panels and related trim, vents, and fasteners, plus the accessories that go with them: clips, closures, screws, and the flashing pieces that fail first. The compatibility gotcha is this: the panel profile and fastener spacing vary by product line, and a screw or clip from a different line won’t seat correctly even if it looks close at the hardware store. That mismatch is a common cause of repeat leaks.

To identify what you have, look for a stamp or label on the back of a panel or on the edge of the trim. Barrette typically prints the product name and a profile code there. If the label is gone, we measure the rib spacing, panel width, and profile height, which gives us the match. When it comes to replacement, Barrette-specific parts are the safest route for a color and profile match; generic aftermarket closures and screws can work as a mechanical substitute, but colors drift and tolerances won’t be exact. For anything visible from the street, we lean toward the Barrette-matched part.

Explore

Styles & brands we work with

  • Kitchen remodeling
  • Bathroom remodeling
  • Home additions & ADU
  • Roofing
  • Windows & doors
  • Driveway & pavers
  • Fence

Signs Your Barrette Roofing Is Failing

Here’s what a failing Barrette roof component looks like, and what’s actually going on underneath.

  • Water stains on the ceiling or attic decking. That’s usually a failed closure or flashing at a valley or penetration, letting water track under the panel. The visible damage is minor; the underlying path is the real issue.
  • Loose or lifted panel ribs. Backed-out fasteners in high-wind zones cause this, and once a rib lifts, water gets underneath and the gasket wears. Coastal Los Angeles homes catch this more than inland.
  • Rust or corrosion at the fasteners. Dissimilar-metal contact or a failed screw gasket lets moisture pool. Our marine air layers accelerate this, especially within a few miles of the ocean.
  • Color fade or chalky finish. UV exposure ages the paint system on metal panels. It’s cosmetic until the finish fails and the substrate starts to powder, which is when we stop calling it cosmetic.
  • Dented areas after hail or debris. Direct impact dents the panel and can break the seal at the seam. Small dents are repairable; large ones often mean panel replacement.

With Los Angeles’s mix of dry heat and coastal moisture, panels near the ocean tend to show fastener corrosion first, while inland homes show finish fade and wind-driven fastener backups.

Before & after

See the difference

Before - Recent ProjectBeforeAfter - Recent ProjectAfter
Recent Project
Before - Full RestorationBeforeAfter - Full RestorationAfter
Full Restoration
Before - Complete UpgradeBeforeAfter - Complete UpgradeAfter
Complete Upgrade

Replacement Cost & What’s Included

For Los Angeles, roof repair runs $470 to $2,125 depending on scope, a full replacement runs $9,440 to $23,600, and a tile-adjacent roof repair sits at $710 to $2,950. What drives the range on a Barrette part swap is access, whether the failure is at a single penetration or spread over a run of panels, and whether fasteners and closures need to be replaced across the whole section.

  • Small repair (single penetration or flashing): $470 to $900.
  • Mid-scope repair (several panels, fasteners, closures): $900 to $1,600.
  • Extensive repair or section replacement: $1,600 to $2,125.
  • Full roof replacement: $9,440 to $23,600, depending on square footage and material.

We quote line items up front: parts, labor, and any accessory hardware, so the number you see is the number you pay. Every repair is covered by our 730-Day Done Right Promise, which applies to the workmanship regardless of whether the part is Barrette or a matched equivalent. If the fix doesn’t hold, we make it right.

DIY or Call Us?

Roof work puts you on a ladder, often at heights and near edges where a fall causes serious injury. A trained professional handles this safely, and for anything higher than a single story or on a steep pitch, that’s the honest answer: call us. What you can safely check from the ground or from inside the attic is the location of a leak, the presence of a Barrette label on a panel edge, and whether a visible rib has lifted. That information helps us match the part faster.

Where DIY goes wrong is fastener match and water path. Using the wrong screw or a mismatched closure can seal one leak and open another, and a second trip up the ladder gets expensive fast. Most jobs are handled in a single visit when we have the right part in hand. If you’ve checked the basics and still have water coming in, call (888) 427-1733.

FAQs

How long does a Barrette roof component last in Los Angeles? A properly installed Barrette metal panel typically lasts 30 to 50 years with the finish intact, but fasteners and closures are the short-lived pieces, usually wearing out in 10 to 20 years in coastal Los Angeles air. Replacement of those small parts extends the whole roof.

Can a failing Barrette part be repaired instead of replaced? Yes, in most cases. A failed closure, screw run, or single panel can be repaired in place; full replacement is only needed when the substrate has rusted through or the finish has failed across a large section. We check the extent before recommending replacement.

How long does the swap take? A single-penetration repair takes a couple of hours and most jobs are completed in a single visit. Section replacement runs longer depending on square footage and weather.

How do you source a Barrette part? We start with the profile code from your label or measurement from the roof, then order the matched Barrette-equivalent or exact-fit part from a distributor. We don’t claim to stock parts or carry them on trucks.

If you’re not sure which part you have, call (888) 427-1733 for a free estimate. We’ll identify the match and price the fix before anyone climbs up.

Beyond roofing, we also work with homeowners on KraftMaid, Cambria, and Silestone products in the kitchens and baths of Los Angeles.

Written by the team at Groundwork Construction Co. of Los Angeles, serving Los Angeles and nearby areas.

Need Construction help nationwide? Licensed & insured · free written estimates
Call (888) 427-1733
Local Service Coverage

Request a Free Estimate in Los Angeles

Tell us what you need - Groundwork Construction Co. of Los Angeles responds fast. No obligation.

By submitting this form you agree to our Privacy Policy and consent to be contacted by phone, email or SMS about your request, including by local professionals who may handle it.

Call Now - 24/7 Dispatch