Driveway & pavers
Kitchen remodeling
Bathroom remodeling
Home additions & ADU
Roofing
Windows & doors
FenceFree written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Jerith Driveway & Pavers: The Los Angeles Owner’s Guide
Jerith-compatible paver and driveway repairs in Los Angeles typically run $8,260 – $21,240 for a full paver driveway installation and $4,130 – $12,980 for a paver patio, depending on square footage, base prep, and whether we’re replacing a failed section or the whole field. We’re an independent Los Angeles service provider – not affiliated with Jerith – and we match the correct paver profile, color, and base spec to your existing Jerith installation. Most owners find out something’s wrong the same way: a paver heaves after a Santa Ana wind event, a corner chips off under a tire, or water starts pooling against the garage threshold instead of draining to the street. Our technicians have up to 12 years of experience reading exactly those failures.
Which Jerith Models This Applies To
Jerith’s driveway and paver line covers interlocking concrete pavers, permeable grid systems, and border/coping units. The trap most Los Angeles homeowners hit is color and thickness drift: a paver that looks identical in a photo can be a 60mm unit where yours is 80mm, or a slightly different dye lot that reads two shades off in direct California sun. Before you order anything, pull a single loose paver and measure it in three places – length, width, thickness. Check the underside for a stamp or mold mark, and photograph the interlock pattern from above. That photo is what lets us match the field.
On the OEM-versus-aftermarket question: for a small cosmetic repair, a quality aftermarket paver in a matched profile and color is often the practical call, especially on a color that’s been discontinued. For structural units under vehicle load – the apron at the driveway mouth, the border course, anything over a failing base – stay with a spec-matched unit rated for the load. Jerith pavers hold up in Los Angeles heat and sun; what actually kills them here is base movement and drainage, not the concrete itself.
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
Signs Your Jerith Driveway & Pavers Is Failing
- Heaving or rocking pavers. A paver that rocks underfoot means the bedding sand has washed out or the base wasn’t compacted to depth. In Los Angeles, this usually traces to irrigation overspray or a downspout dumping against the driveway.
- Chipped corners and spalled faces. Vehicle weight on an unsupported edge causes this. Spalling that exposes aggregate often points to a paver that took too much impact where the base has settled.
- Pooling water against the house or garage. Standing water after a rain means the slope has flattened or the drainage path is blocked. Left alone, that water finds the foundation and the base course.
- Sand washing out of the joints. Joint sand loss lets pavers shift and weeds take hold. On a Jerith grid system, missing joint material means the interlock is no longer doing its job.
- Widespread color fade or efflorescence. White chalky bloom is salt migrating through the paver. It’s cosmetic, but persistent bloom on older units can signal a surface that’s breaking down.
See the difference
Before
After
Before
After
Before
AfterReplacement Cost & What’s Included
In Los Angeles, paver driveway installation runs $8,260 – $21,240, paver patio installation $4,130 – $12,980, driveway replacement $5,900 – $16,520, and driveway sealing $295 – $825. What drives the range: square footage, how much base has to be excavated and re-compacted, whether we’re matching a discontinued color, and access – a narrow Los Angeles driveway with parked cars on both sides slows hauling and adds labor.
Our quotes are line-item and upfront: you see the paver unit cost, base prep, sand, edge restraint, and labor separately, and the number you see is the number you pay. Your bill is backed by our 730-Day Done Right Promise – if it’s not done right, we make it right. Call (888) 427-1733 for a free estimate and design consult.
DIY or Call Us?
There’s real value in what an owner can check safely. Walk the driveway after a hose-down and note where water pools, photograph the interlock pattern, measure a loose unit, and pull weeds and top off joint sand on a sound, flat field. That homework makes our estimate sharper.
Where DIY goes wrong: re-setting pavers over a base that’s still moving. If you reset a rocking paver without fixing the drainage or base underneath, it fails again within a season – and matching a Los Angeles color that’s out of production is where most homeowner attempts stall. Structural work over a failed base, edge restraint, and slope correction are jobs for a crew with compaction equipment. Call (888) 427-1733 and we’ll tell you honestly whether you need a spot fix or a full replacement.
FAQs
A properly installed Jerith paver field with a solid base and working drainage should last 25 to 30 years or more in Southern California. The pavers themselves outlast the base – it’s the prep, drainage, and joint sand that decide real lifespan here. Call (888) 427-1733 for an exact quote – estimates are free.
Often yes. If the failure is isolated – one settled area, a chipped border course, a drainage issue at the driveway mouth – a spot repair with matched units is usually the right call. If the base is failing across the field, patching just kicks the problem down the road. We’ll tell you which you’re facing.
A spot repair is typically a single-visit job. A full driveway replacement usually takes several days, factoring excavation, base compaction, and cure time before you drive on it. Call (888) 427-1733 for a timeline on your specific driveway.
By measurement, mold mark, and pattern photo – not by eyeballing color. We spec-match the profile, thickness, and color to your existing installation, and when a color is discontinued we walk you through the closest aftermarket equivalent. Estimates are free; call (888) 427-1733.
When a Jerith paver fails, the fix is part match plus base and drainage, and that’s exactly what we scope. We install and repair Jerith-compatible driveways and pavers across Los Angeles, backed by upfront pricing and the 730-Day Done Right Promise. We also service KraftMaid, Cambria, and Silestone in other divisions. Call (888) 427-1733 for your free estimate – a live person answers, 24/7.
Written by the team at Groundwork Construction Co. of Los Angeles, serving Los Angeles and nearby areas.