A Groundwork company - serving Los Angeles, CA

Belgard Driveway & Pavers in Los Angeles, CA

Driveway & paversDriveway & pavers
Kitchen remodelingKitchen remodeling
Bathroom remodelingBathroom remodeling
Home additions & ADUHome additions & ADU
RoofingRoofing
Windows & doorsWindows & doors
FenceFence
Every visit starts with

Free written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled

We have financing partners for your dream remodel*On approved credit; ask us about your options
Get your free estimate

Belgard Driveway & Pavers: The Los Angeles Owner’s Guide

We install Belgard driveway and paver systems across Los Angeles, and full driveway installation typically runs $8,260 – $21,240 depending on square footage, base prep and the Belgard series you choose. Repair of a single failed section is far less. Most owners call us after noticing loose or rocking pavers, a sunken strip near the garage apron, or sand washing out between joints after a rain. Those three symptoms account for most of the Belgard paver calls we handle in Los Angeles, and each points to a different failure underneath the surface.

Call (888) 427-1733

Key Takeaways

  • Belgard pavers are modular units, not a single part – “replacement” usually means lifting, re-basing and re-setting a section, not swapping a component.
  • Most Los Angeles failures trace to base prep and drainage, not the paver itself.
  • Installed paver driveway pricing in Los Angeles runs $8,260 – $21,240; single-section repair is priced separately.
  • Our technicians have up to 12 years of experience and every job carries the 730-Day Done Right Promise.

Which Belgard Models This Applies To

Belgard’s driveway lineup covers several distinct product families, and matching the right replacement matters more than most homeowners expect. The most common in Los Angeles are the Urbana Stone and Catalina slab-style pavers, the Aqua-Roc and Mega-Arbel interlocking systems, and the Holland and Tremron-compatible utility pavers used on older driveways. Each has its own nominal dimensions, thickness and joint spacing, and a Catalina slab will not key correctly against an Urbana Stone field.

To identify what you have, pull a paver from an edge or a low-traffic corner and measure length, width and thickness in millimeters. Belgard stamps many units on the underside, and a clear photo of the stamp plus the measurement gets us to the right series fast. Standard driveway units run around 60mm thick and that dimension is the one that matters – a 50mm wall unit laid in a driveway will crack under vehicle load within a season or two.

On the OEM-versus-aftermarket question: for a color-matched patch on an existing field, genuine Belgard is usually the only way to get a clean match, because dye lots shift between production runs and even Belgard’s own colors vary slightly year to year. For a full replacement, a quality equivalent from another manufacturer can work if the thickness and joint pattern are matched correctly. We’re an independent installer and not affiliated with Belgard, so we quote both paths honestly and let the job decide. We also service KraftMaid, Cambria and Silestone on the interior side for homeowners doing a full-property project.

Explore

Styles & brands we work with

  • Kitchen remodeling
  • Bathroom remodeling
  • Home additions & ADU
  • Roofing
  • Windows & doors
  • Driveway & pavers
  • Fence

Signs Your Belgard Driveway & Pavers Is Failing

  • Rocking or loose pavers. The bedding sand has migrated or the base aggregate wasn’t compacted in lifts. Once a unit rocks, water gets under it and the movement spreads to its neighbors.
  • Sunken strips or dips. Usually soft subgrade or a base that wasn’t deep enough for Los Angeles clay soil, which swells and shrinks with our wet-dry cycle. A dip that appears after a rainy season is the signature.
  • Sand washing out of the joints. Joint sand loss points to drainage running across the surface instead of off it. On a slope toward the garage, this compounds fast.
  • Efflorescence – white chalky staining. Mineral salts rising through the paver. Some is normal in the first year; recurring bloom means moisture is trapped under the field.
  • Cracked or chipped units at the apron. Vehicle load concentrated at the transition to the garage slab, or a base edge that wasn’t restrained. This is the failure we see most in the hillside neighborhoods.

In Los Angeles, the pattern we see most is spring settling and joint sand loss after the winter rains, especially on driveways that slope toward the street. Our clay-heavy soil holds water, and a base that was marginal in August will show its fault lines by March.

Replacement Cost & What’s Included

Paver driveway installation in Los Angeles runs $8,260 – $21,240 installed, and driveway replacement runs $5,900 – $16,520 for a straight concrete or paver swap. Single-section Belgard repair – lifting, re-basing, re-setting and re-sanding – is priced separately and is almost always less than a full replacement. Patio work, if the same trip covers it, runs $4,130 – $12,980 for paver patio installation in Los Angeles.

What drives the range: square footage, how much base has to be excavated and hauled off, whether the slope needs correction, and the Belgard series you choose. Our quotes are upfront with no surprises – a written line-item breakdown of base, pavers, edge restraint, polymeric sand and labor, so you can see exactly what you’re paying for. The number you see is the number you pay. Every job is backed by the 730-Day Done Right Promise.

Before & after

See the difference

Before - Recent ProjectBeforeAfter - Recent ProjectAfter
Recent Project
Before - Full RestorationBeforeAfter - Full RestorationAfter
Full Restoration
Before - Complete UpgradeBeforeAfter - Complete UpgradeAfter
Complete Upgrade

DIY or Call Us?

What you can safely check: whether a paver rocks underfoot, whether joint sand is missing, whether water pools against the garage, and whether the edge restraint is still pinned. A photo of the failing section and a measurement of the paver gets you a fast quote.

Where DIY goes wrong: re-setting a section without proper base compaction looks fine for a season and then fails twice as fast, and lifting a field of interlocked pavers by hand without disturbing the neighbors rarely works cleanly. Hauling and re-compacting base at driveway depth is also heavier work than most homeowners expect. If the failure is at the apron or a slope, the repair is a base problem, not a surface one – and that’s the call worth making. Our technicians have up to 12 years of experience and arrive in uniform. Call (888) 427-1733 for a free estimate.

FAQs

Get a Free Estimate on Your Belgard Driveway & Pavers

If your Belgard driveway is rocking, settling or losing joint sand, the fix starts with a straight answer on what’s failing and what it costs. Call (888) 427-1733 for a free estimate – our calls are answered by a live person 24/7, and every job is backed by the 730-Day Done Right Promise and upfront pricing with no surprises.

Written by the team at Groundwork Construction Co. of Los Angeles, serving Los Angeles and nearby areas.

Need Construction help nationwide? Licensed & insured · free written estimates
Call (888) 427-1733
Local Service Coverage

Request a Free Estimate in Los Angeles

Tell us what you need - Groundwork Construction Co. of Los Angeles responds fast. No obligation.

By submitting this form you agree to our Privacy Policy and consent to be contacted by phone, email or SMS about your request, including by local professionals who may handle it.

Call Now - 24/7 Dispatch