A Groundwork company - serving Los Angeles, CA

Mighty Buildings Driveway & Pavers in Los Angeles, CA

Driveway & paversDriveway & pavers
Kitchen remodelingKitchen remodeling
Bathroom remodelingBathroom remodeling
Home additions & ADUHome additions & ADU
RoofingRoofing
Windows & doorsWindows & doors
FenceFence
Every visit starts with

Free written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled

We have financing partners for your dream remodel*On approved credit; ask us about your options
Get your free estimate

Mighty Buildings Driveway & Pavers: The Los Angeles Owner’s Guide

We install Mighty Buildings-compatible driveway and paver systems across Los Angeles, with paver driveway installation typically running $8,260 – $21,240 and concrete driveway work at $5,310 – $14,160 depending on square footage, base prep and paver selection. Patching and sealing visits can often be scheduled the same day for smaller repairs. Most owners discover a failure the same way: a paver edge lifts after a rainy season and rocks underfoot, a hairline crack in the slab spreads across a full panel, or water starts pooling against the foundation where it never used to. By the time a paver shifts an inch or two, the base beneath it has usually been moving for months, and that is the part of the problem you can’t see.

Call (888) 427-1733

Which Mighty Buildings Models This Applies To

Mighty Buildings builds factory-finished panels and modules, and their driveway and hardscape packages are specified around the exact panel footprint, slab elevation and finish grade of each model line. That means the paver type, edge restraint, base depth and drainage pitch called out for one of their single-story configurations does not automatically carry over to a two-story or ADU layout, even when the finished look is identical. The compatibility gotcha most Los Angeles owners run into: Mighty Buildings’ panelized foundations and step-down thresholds can sit lower or higher than a conventional stem wall by a few inches, so an off-the-shelf paver course or standard concrete thickness that works on a stick-built house may not meet the finished floor height cleanly.

To identify the right system, climb into the records before the yard. The panel or module serial label is typically affixed near the utility chase or on the exterior wall inside the access panel, and the hardscape spec sheet in your owner packet lists the paver series, base aggregate and edge restraint by model revision. When that paperwork is missing, we measure the existing paver thickness, joint width and base depth in place and match the OEM or a quality aftermarket equivalent to the original spec range. We’re an independent service provider, not affiliated with Mighty Buildings, and our technicians have up to 12 years of experience matching hardscape to panel-built homes. Need something closer to the original? OEM parts take longer to source. A compatible aftermarket paver or slab spec installed correctly usually performs the same, gets you a working driveway sooner, and costs less.

Explore

Styles & brands we work with

  • Kitchen remodeling
  • Bathroom remodeling
  • Home additions & ADU
  • Roofing
  • Windows & doors
  • Driveway & pavers
  • Fence

Signs Your Mighty Buildings Driveway & Pavers Is Failing

Look for these five symptoms on any panel-built driveway in Los Angeles. Each one points to a cause below the surface:

  • Pavers rocking or lifting at the edge. Water has worked into the bedding layer and the base aggregate has shifted. It gets worse every rainy season.
  • Hairline cracks spreading across a concrete panel. Usually a sign the subgrade settled unevenly beneath the slab, not just surface wear.
  • Pooling water against the panel foundation. The slope has flattened over time or the drainage pitch was off from the start. Standing water near the foundation is a problem for the whole structure.
  • Joint sand washing out and weeds in the seams. The joint sand has eroded and the paver system is losing its interlock, which lets water in faster.
  • Heaved or frost-affected pavers after a wet winter. In Los Angeles this is less about frost and more about saturated base after heavy storms. Once the base stays wet, it won’t drain properly and the pavers move.
Before & after

See the difference

Before - Recent ProjectBeforeAfter - Recent ProjectAfter
Recent Project
Before - Full RestorationBeforeAfter - Full RestorationAfter
Full Restoration
Before - Complete UpgradeBeforeAfter - Complete UpgradeAfter
Complete Upgrade

Replacement Cost & What’s Included

Installed pricing runs a wide range depending on how much base work is needed. Here’s how Los Angeles projects typically land:

Service Typical Installed Price
Paver driveway installation $8,260 – $21,240
Concrete driveway installation $5,310 – $14,160
Asphalt driveway paving $4,130 – $10,620
Driveway replacement $5,900 – $16,520
Driveway sealing $295 – $825

The low end is a straight paver or slab replacement over sound base. The high end means real base work: excavation, new aggregate, edge restraint and drainage correction. Replacement pricing includes removal and disposal, base preparation, materials and installation. That’s parts and labor in one number. Call (888) 427-1733 for a free, written quote. Every project carries our 730-Day Done Right Promise, and 0% financing for 18 months with $1,000 off projects over $10,000 is available.

DIY or Call Us?

What you can safely check on your own: measure paver thickness and joint width, photograph cracks and pooling areas, and confirm the panel serial number for the part match. What tends to go wrong: base repair. Swapping pavers without fixing the aggregate underneath just resets the clock, and water will find the same gap in six months. Concrete replacement is heavier, harder and more dangerous to handle than most owners expect, and it’s easy to get the finished grade wrong, which sends runoff toward the foundation. That’s a structure problem, not a driveway problem. When the ground under a panel-built home is involved, base and drainage matter more than the surface material. Call (888) 427-1733 for a free estimate before you rent a tool or order a single pallet.

FAQs

Need Construction help nationwide? Licensed & insured · free written estimates
Call (888) 427-1733
Local Service Coverage

Request a Free Estimate in Los Angeles

Tell us what you need - Groundwork Construction Co. of Los Angeles responds fast. No obligation.

By submitting this form you agree to our Privacy Policy and consent to be contacted by phone, email or SMS about your request, including by local professionals who may handle it.

Call Now - 24/7 Dispatch