Fence
Kitchen remodeling
Bathroom remodeling
Home additions & ADU
Roofing
Windows & doors
Driveway & paversFree written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Iron Fence in El Segundo, CA: What It Costs and What We Actually Build
A wrought iron fence in El Segundo runs $3,500 to $9,000 for a typical residential front or side yard, and most jobs take two to four weeks from signed estimate to final walkthrough. That number covers fabrication, hauling, setting posts in concrete and the finish coat. Call us at (888) 427-1733 for a free on-site estimate, and we’ll walk the property line with you and put a real number in writing before any steel gets ordered.
How We Sequence an Iron Fence Job From First Stab to Final Weld
Iron work is not a same-day install. The steel has to be measured, fabricated and coated, and the posts need cure time before anything gets bolted or hung. Here’s the actual run of a job here.
Stage 1: Site walk and line layout (day 1)
We start by finding your actual property corners. In El Segundo’s older bungalow lots, the original iron stakes in the alley are often gone or paved over, so we frequently plot from the plat map and the recorded lot dimensions before we set a single string. You decide the fence line and gate locations on this visit. Measurements we take here become the fabrication sheet, so a change later means re-fabricating sections, not just shifting a panel.
Stage 2: Utility locating and permit filing (days 2 through 7)
We call 811 so nobody puts a post through a sewer lateral or a gas stub. A fence here usually sits within height and setback limits that don’t require a building permit, but if you’re going taller than the local limit or fencing a corner lot where sight distance matters, the small city-planning department wants to see the plan. We handle filings and walk the comments back to you in plain English.
Stage 3: Demo, prep and footing set (days 3 through 5, on-site)
Old fence comes out, posts get set in concrete footings 24 to 30 inches deep. In El Segundo soil, sandy and often hit with groundwater from coastal irrigation, footings need to be deep enough that the post can’t lift or lean. This stage involves no welding, just set and cure. Cure is typically a few days, and the driver is that nothing hangs until the concrete is hard.
Stage 4: Panel and gate install (days 6 through 8, on-site)
Pre-fabricated panels and gates are set, plumbed and fastened. You decide hinge style, latch hardware, and whether gates swing or slide. This is where we check clearances against the existing stucco wall, the driveway apron, and any drainage swale, because an iron gate that scrapes a walkway is a repair, not an install.
Stage 5: Finishing and walkthrough (day 9 or 10)
Touch-up on welds, final coat over any field cuts, and a walkthrough where you inspect every gate before we collect final payment. Changes are settled before the last panel goes up. Our materials come through partners like Sakrete for the footings where relevant, and every job sits under our 730-Day Done Right Promise – if a gate sags or a weld fails, we make it right.
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
The Iron Fence Options You’ll Actually Choose Between
- Real wrought iron vs. steel – true wrought iron is heavier, hand-forged and expensive; most residential El Segundo jobs use ornamental steel, which is lighter, welds cleanly and lands in the $3,500 – $9,000 range. The trade-off is weight and longevity for a hero gate, versus a lower price for a run-of-yard fence.
- Powder coat vs. wet paint – powder coating is baked on and holds up against salt air far better than paint, and it’s the spec we push for coastal lots. Wet paint costs less but needs a re-coat every few years.
- Bar spacing and height – 6-foot panels suit most front yards; 4-foot works where you want visibility. Tighter spacing adds material and cost; check the height limit before you settle.
- Posts and footings – tubular steel posts set in concrete or anchored to existing masonry. We spec galvanized or coated fasteners so the hardware doesn’t rust out before the fence does.
- Gates – a pedestrian gate, a drive gate, or both. Drive gates drive the number more than anything else on the job because of hardware and weight.
Iron Fence Pricing in El Segundo, CA
Our lead range here is $3,500 to $9,000, and a modest single-run side fence sits near the bottom while a full front run with a drive gate lands near the top. Call (888) 427-1733 for a line-item quote – estimates are free.
| Line item | Typical range |
|---|---|
| Per linear foot, ornamental steel, installed | $70 – $130 |
| Pedestrian gate with hardware | $600 – $1,500 |
| Drive gate with hardware | $1,500 – $3,500 |
| Old fence removal | $300 – $800 |
| Powder coat upgrade over paint | $400 – $1,200 |
Four things push a job toward the high end: lineal footage, gate count and hardware, whether a rear fence means hauling materials through the house or around a narrow side yard, and whether we’re replacing a post set that’s deteriorated at the footing. What’s included in a written estimate is the steel, fabrication, footings, install, finish and cleanup. What usually isn’t: moving a sprinkler line, cutting back overgrown planting, or repairs to a stucco wall the fence anchors into.
See the difference
Before
After
Before
After
Before
AfterWhy El Segundo Lots Make This Job a Little Different
This is a built-out city, so almost every iron fence here replaces something that’s already on the ground, and lot lines are tight. Most of the housing stock is 1940s and 1950s bungalow and post-war tract, set on 5,000 to 6,000 square foot lots, and a front yard is often only a few feet from the sidewalk to the porch. That changes pacing: we’re demoing a fence, not clearing a field. The marine air off Santa Monica Bay also matters to the hardware. Salt fog eats zinc hardware and cheap paint, so we spec powder coat and coated fasteners on El Segundo jobs as a rule, not an upgrade. If you’re on the east side closer to the aerospace campus, delivery and staging can be more tightly scheduled than a mile away, which we plan for at the estimate. Working through the city’s own building department, not the county, keeps review comments quick. If the fence is part of a full Fence Installation in El Segundo, we plan the layout alongside the rest rather than rebuild around it.
Serving El Segundo, CA – Our Local Coverage Area
We serve El Segundo and nearby communities. Use the map below to see the area we cover. If you’re nearby, we can almost certainly help.
Frequently Asked – Iron Fence in El Segundo
Two to four weeks from signed estimate to walkthrough, and the install itself is usually about three to five days on site. The rest is fabrication and footing cure. Call (888) 427-1733 for a timeline tied to your lot.
Usually not for a standard height residential fence, though corner lots and taller runs can trigger a plan review through the city’s small planning department. We check the height limit and set-back rules before we order steel. Call us to confirm what your property needs.
No plumbing, electrical or structural work is involved in an iron fence install – only post footings. We call 811 to keep locates clean, and we plan footings around existing sewer and gas lines. Contact us before you dig anything.
Most jobs land between $3,500 and $9,000 depending on length, gates and finish. A short side run sits at the low end; a full front yard with a drive gate sits at the top. Call (888) 427-1733 for an exact number.
Yes – our 730-Day Done Right Promise covers workmanship, so if a gate sags or a footing fails, we come back and make it right. We put that in writing. Call (888) 427-1733 to schedule.
Get an Iron Fence Estimate in El Segundo
We walk the property line, measure the run, check the property corners and hand you a written line-item quote with no surprises. Most El Segundo iron fence jobs run $3,500 to $9,000, and our technicians bring up to 12 years of experience to the layout. Call (888) 427-1733 for a free estimate – a live person answers, day or night. If you’re adding hardscape while we’re on site, owners often pair this with Patios, Walkways & Pool Decks in El Segundo so both are coordinated.
Fence Installation is our wider service if you’re planning more than the iron run, and our El Segundo page covers the rest of what we work on locally. If you’re considering an accessory unit or garage conversion alongside the yard work, owners often pair this with ADU Design & Permitting in El Segundo.
Written by the team at Groundwork Construction Co.