Kitchen remodeling
Bathroom remodeling
Home additions & ADU
Roofing
Windows & doors
Driveway & pavers
FenceFree written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Tub-to-Shower Conversion in Topanga, CA: What It Takes and What It Costs
A tub-to-shower conversion in Topanga typically runs $3,500 to $10,000 and takes one to three weeks of on-site work, depending on whether the drain stays put and how much of the original surround has to come out. The job means removing the tub, reshaping the drain and waterproofing, rebuilding the wall substrate, setting a new pan and tile or a molded surround, and resetting the valve. Call (888) 427-1733 for a free on-site estimate before anything gets ordered.
Most Topanga conversions we see start with the same trigger: a cast-iron or fiberglass tub that no one has used in years sitting in a narrow hall bath while everyone fights over the other shower. The conversion turns that dead space into a walk-in. Because so many homes here are remote canyon properties, we build these jobs to be finished in as few trips as possible, with materials staged and confirmed before demo day.
How the conversion actually runs, day by day
We sequence the work in five stages. The first two are where the surprises live, and they’re also where your decisions get locked in.
- Stage 1 – Measure and open the wall (day 1, about 4 hours). We pull the old surround or tile back to the studs, expose the valve and drain, and check the framing for rot. In canyon cabins off Old Topanga, that’s often where we find original 1950s dry-set tile over unsealed backer or a tub set on a raised platform that the new pan has to account for. You’ll decide here whether the shower footprint stays tub-sized or extends into closet or wall space.
- Stage 2 – Rough plumbing and inspection (days 2 – 3). If the drain relocates to a center position, we cut and re-route, which may mean opening the subfloor. The valve gets swapped to a new pressure-balance or thermostatic unit. Then the county inspection happens, and nothing gets closed up before it passes. You choose the valve trim and finish at this stage, because the rough-in depth depends on it.
- Stage 3 – Pan and waterproofing (days 4 – 6). We set the shower pan, slope it to the drain, and install a bonded waterproof membrane up the walls and over the curb. This is the stage that decides whether the shower leaks in five years, so we don’t rush it, and we flood-test before tile goes on.
- Stage 4 – Tile and finish (days 7 – 12). Wall tile, grout, and any accent or niche work. You’ll have chosen tile size and grout line back in stage 1; anything larger than 12×24 needs flatter substrate and adds a day.
- Stage 5 – Glass, trim, and punch (days 13 – 15). Glass panel or door goes in, the valve trim and showerhead get installed, and we walk the job with you. Small jobs finish closer to day 10; jobs that relocate the drain or open a wall push toward three weeks.
One note on safety and code: the waterproofing, the valve, and the drain connection are the parts you don’t want to improvise. A wrong pan slope doesn’t announce itself until water is in the ceiling below. We handle those stages with our own trades, and the county inspector signs off before tile goes down.
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
The choices that actually change the outcome
Once the drain is settled, the conversion comes down to a handful of decisions. Here’s how the options trade off.
- Tile versus a molded surround. A tiled shower with a membrane system costs more and takes longer, but it lasts decades and takes any look you want. A fiberglass or acrylic surround is faster and cheaper, and it’s the right call for a rental or a hall bath you want done and forgotten. Neither is better, but the wrong one for your house gets replaced.
- Pan type: site-built mud bed versus a pre-formed pan. A mud bed lets us match any footprint, so it fits the odd dimensions of canyon cabins. A pre-formed pan is faster and more predictable, but it only works if your existing opening is a standard size.
- Drain position. Keeping the tub drain where it is usually saves $400 to $900 and a day or two. Centering it looks better and drains faster, and it’s worth it if the subfloor is already open.
- Valve and finish grade. A basic pressure-balance valve and chrome trim is the sensible floor. Thermostatic valves, brushed or matte finishes, and hand-shower combos move up from there. Kohler and Moen both make solid mid-range units; the upgrade is worth it if you’ve ever been scalded by a toilet flush.
- Glass. A fixed panel keeps the shower feeling open and costs less than a framed door. A frameless door or a full enclosure is the upgrade, and it needs the tile walls to be square and flat.
If you’re also rethinking the rest of the room while the walls are open, that’s the moment to look at Bathroom Remodeling in Topanga, since the demo is already done. And homeowners often pair this with roof and exterior work while crews are on site, such as Metal Roofing in Topanga.
What Tub-to-Shower Conversion costs in Topanga, CA
In Topanga, a tub-to-shower conversion runs $3,500 to $10,000 all-in, with most done-for-you conversions landing in the $5,000 to $8,000 range. Below that range, you’re looking at a molded surround and the drain staying put. Above it, you’re relocating plumbing, tiling to the ceiling, or adding frameless glass.
| Line item | Typical range |
|---|---|
| Demo, haul-out, rough prep | $600 – $1,400 |
| Plumbing rough-in (drain and valve) | $800 – $2,200 |
| Pan, waterproofing, flood test | $900 – $2,000 |
| Wall tile and setting materials | $1,200 – $3,800 |
| Glass panel or door | $600 – $2,200 |
| Permit and inspection | $300 – $900 |
What moves a job to the high end: relocating the drain, replacing a rotted subfloor or a tub set on a framed platform, opening a wall to gain width, upgrading to a thermostatic valve, or tiling large-format slabs that need a flatter substrate. What keeps it low: a standard footprint, a pre-formed pan, and a molded surround.
Every written estimate lists the demo, plumbing, waterproofing, tile, glass, and permit as separate lines, so you see exactly what each part costs. The price you sign is the price you pay, and we hold it with our 730-Day Done Right Promise rather than a one-year workmanship line. If the walls open up and we find something we didn’t expect, you hear it before we touch it, not after.
See the difference
Before
After
Before
After
Before
AfterWhat Topanga homes specifically do to this job
Topanga is unincorporated canyon country, and the county permitting, not a city building department, runs the shower valve and drain work here. That’s slower, and it’s why we plan the inspection into the schedule rather than discovering it. Below the permit, the housing stock does the rest. Most of the homes we work in around 90290 are hand-built canyon cabins or owner-builder houses from the 1920s through the 1970s, sitting on pier-and-post or caisson foundations cut into steep slope, and plenty of them carry non-permitted past work. That means a tub that looks simple on the surface can have a drain running through a joist bay the original builder never planned for.
Access shapes the job as much as the plumbing. On the private roads off Topanga Canyon Blvd and Old Topanga, a flatbed with tile or a full-size delivery truck often can’t make the grade or the turn, so we stage materials at the highway and plan around smaller loads. Getting the haul-away right on the first trip matters more here than anywhere. It’s the same reason we like a full-scope partner: with Bathroom Remodeling under one contract, we’re not sending three different crews up the canyon.
Serving Topanga, CA – Our Local Coverage Area
We serve Topanga and nearby communities. Use the map below to see the area we cover. If you’re nearby, we can almost certainly help.
Frequently asked – Tub-to-Shower Conversion in Topanga
A tub-to-shower conversion in Topanga takes about 10 to 15 working days on site, plus a few days for permit review. Jobs that keep the drain in place finish near the low end. Call (888) 427-1733 and we’ll give you a realistic date range for your actual bath.
Yes. Because the plumbing valve and drain change, LA County requires a permit and an inspection of the rough-in before the shower is closed up. We pull it and pass it, and the signed-off inspection is part of your file.
Usually, yes. If your new shower footprint sits over the existing tub drain, we set the pan around it and save the $400 to $900 a relocation costs. A centered drain is nicer, but it isn’t required, and it’s a call you can make once the wall is open and we’ve looked at the framing.
The full range in Topanga is $3,500 to $10,000, with most jobs landing between $5,000 and $8,000. Tile versus a molded surround and whether the drain relocates are the two biggest levers. Call (888) 427-1733 for a line-item quote on your bath.
Our work is covered by the 730-Day Done Right Promise. That covers the labor and the waterproofing we install. Manufacturers cover their own fixtures and glass separately, and we register those for you so there’s no gap. Call (888) 427-1733 with questions about coverage before you sign anything.
Get a free on-site estimate for your Topanga conversion
We’ll walk your bath, measure the existing tub opening, and tell you straight what the drain and framing will allow before you commit. You’ll get a written, line-item estimate and a realistic start date, with no pressure and no change orders. Groundwork Construction Co. covers Topanga and the surrounding canyons, and homeowners in nearby Calabasas, Santa Monica, Malibu, and Agoura Hills often ask us to look at their bath while we’re close. We also work with Abodu and Cover on adjacent building projects. Call (888) 427-1733 to schedule your free estimate.
Written by the team at Groundwork Construction Co.