Driveway & pavers
Kitchen remodeling
Bathroom remodeling
Home additions & ADU
Roofing
Windows & doors
FenceFree written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Asphalt Driveways & Resurfacing in San Fernando, CA: What It Costs and How Long It Takes
Asphalt driveway paving in San Fernando typically runs $3,500 – $9,000, and a full resurfacing (overlay) of an existing drive usually lands at the lower half of that range. The job takes two to three working days: one to demo, grade and compact the base, one to lay and roll the asphalt, then a short return visit for sealcoat once the surface has cured. Call (888) 427-1733 for a free on-site estimate; we’ll measure the drive and give you a written line-item quote before any equipment shows up.
From Broken Base to Finished Surface: How We Resurface an Asphalt Drive in San Fernando
Every resurfacing we do in San Fernando follows the same sequence. Skipping a stage is how asphalt fails two winters later, so the schedule below is fixed, not flexible.
Stage 1: Site check and moisture test (Day 1, about an hour)
Before quoting, we walk the drive and check for alligator cracking, low spots where water pools, and any soft patches that fail underfoot. Old driveways built on tight mid-century lots often hide a shallow base that’s settled unevenly, so we probe a couple of spots to confirm the subgrade will hold. You’ll get a written recommendation on the spot: overlay, mill-and-overlay, or full replacement.
Stage 2: Demo and base work (Days 1 – 2)
We break out failed sections, haul off spoils, and re-grade the sub-base to a 2% slope so runoff moves toward the street rather than the foundation. On a San Fernando lot, that slope is more than a formality: with summer heat and occasional heavy rain, flat asphalt drives pool water and accelerate cracking. Compaction happens in lifts, roughly four inches at a time, using a plate compactor and roller.
Stage 3: Asphalt lay-down (Day 2)
Hot-mix asphalt is placed at 2 – 3 inches compacted depth for a residential overlay and rolled while it’s still workable. Edges get feathered into the apron at the street and into the garage threshold so water doesn’t catch. This is the day the drive becomes off-limits to vehicles for 24 – 48 hours, which is the main scheduling constraint for most households.
Stage 4: Cure and cure-time guidance (Days 2 – 4)
Asphalt continues to cure for 6 – 12 months, but it’s drivable within two days and safe for foot traffic the same evening. We walk you through the light-use window, the spots to avoid parking on during the first heat wave, and how to spot a problem early.
Stage 5: Sealcoat (2 – 6 months later, half a day)
Sealcoat protects the asphalt from UV damage, which matters in San Fernando’s summer sun, and refreshes the black surface. We schedule it once the asphalt has finished its initial cure so the sealer bonds instead of trapping moisture. Written recommendations come back with the original job file.
If you’re planning the driveway as part of a broader exterior project, the full scope lives on our Driveway & Pavers in San Fernando page, and our Driveway & Pavers service hub covers the whole category.
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
The Options That Actually Change the Number
Asphalt isn’t one product. What you pick for each of these choices moves the price by thousands, and each has a real trade-off.
- Overlay vs. mill-and-overlay vs. full replacement. An overlay (2 inches of new asphalt over the existing surface) is the cheapest option at the low end of the $3,500 – $9,000 range, but only works if the base is sound. Mill-and-overlay removes 1 – 2 inches of old surface first so the new layer meets the garage apron cleanly; expect $1,000 – $2,000 more. Full replacement is required when the base has failed.
- Hot-mix vs. cold-patch for repairs. Hot-mix bonds properly and is what we install. Cold-patch is a temporary fix that fails within a season in San Fernando heat and doesn’t belong on a driveway you plan to keep.
- Standard vs. fiber-reinforced asphalt. Fiber-reinforced mix resists cracking better on older, settling bases and adds roughly 10 – 15% to the material line. On a 1960s San Fernando lot with a shallow base, it’s often worth it.
- Edge restraint: asphalt curb vs. concrete curb vs. none. A concrete edge curb adds $400 – $900 but keeps the asphalt from spreading outward under load. On tight lots where the drive is wedged between a fence and the house, that restraint matters.
- Sealcoat: included or priced separately. We quote sealcoat as a separate line so you know what the future maintenance costs. Expect $250 – $700 when it’s due.
What Asphalt Driveways & Resurfacing Costs in San Fernando, CA
Residential asphalt paving in San Fernando runs $3,500 – $9,000 for a typical two-car drive, and full driveway replacement (base work included) lands in the $5,000 – $14,000 band. Here’s the line-item breakdown we build into a written estimate:
| Line item | Typical range |
|---|---|
| Asphalt paving (overlay or new drive) | $3,500 – $9,000 |
| Full replacement with base work | $5,000 – $14,000 |
| Sealcoat (scheduled separately) | $250 – $700 |
| Edge curb (concrete) | $400 – $900 |
Five variables drive a job to the low or high end:
- Drive size. Square footage is the single biggest lever. A single-car drive barely makes the low end; an extended two-car or RV-width drive pushes toward $9,000.
- Base condition. If the old asphalt sits on a settled or clay-heavy subgrade, we’re rebuilding base, not just topping it.
- Access. A driveway behind a tight mid-century lot with limited street parking means hand-carrying materials, which adds labor.
- Drainage work. Adding a channel drain or re-grading toward the street adds time and materials.
- Sealcoat bundling. Booking the sealcoat with the paving job rather than two years later usually saves a mobilization charge.
Our quotes are fixed-pricing, no change orders once work starts, and include haul-off and cleanup. Call (888) 427-1733 for a free estimate.
See the difference
Before
After
Before
After
Before
AfterWhat San Fernando’s Own Building Department and Housing Stock Do to a Driveway Job
San Fernando is one of the few LA-area cities that runs its own building department and plan check. That matters here: a driveway that touches the public right-of-way, changes drainage flow, or grades toward the street often triggers a right-of-way or grading review from the City of San Fernando rather than LA County or City of LA, and inspectors and plan checkers in a city of about 2.5 square miles tend to know the local contractors by name. We pull the permits and pass the inspections, so nothing gets built on a verbal okay.
The housing stock then shapes the work itself. Much of San Fernando’s single-family inventory is postwar and older bungalows and small stucco homes on tight lots, and the asphalt drives on those parcels are often original or second-generation. We routinely find shallow bases that have settled toward the foundation, cracks radiating from the garage apron, and low spots along the fence line where runoff has been collecting for decades. Add intense Valley summer sun and the UV damage shows up as chalky, brittle asphalt by year ten. Recognizing that pattern early is what separates a resurfacing that holds from one that fails.
Serving San Fernando, CA – Our Local Coverage Area
We serve San Fernando and nearby communities. Use the map below to see the area we cover. If you’re nearby, we can almost certainly help.
Frequently Asked – Asphalt Driveways & Resurfacing in San Fernando
Most residential resurfacing in San Fernando takes two to three working days from demo to final roll, plus a separate half-day sealcoat visit two to six months later. Plan for the drive to be off-limits to vehicles for 24 – 48 hours after the asphalt goes down. Call (888) 427-1733 for a written schedule with your estimate.
Permits depend on what the job touches: a like-for-like overlay usually doesn’t require one, while work that changes grading, drainage, or the public right-of-way through the City of San Fernando typically does. We confirm the requirement during the site visit and pull what’s needed. Call (888) 427-1733 to talk through your specific driveway.
Yes, when the base is sound. An overlay adds 2 inches of new asphalt over the existing surface and saves $1,500 – $3,000 compared to full replacement. If the base has failed or the asphalt has deep alligator cracking, an overlay is money wasted and we’ll tell you so. Call (888) 427-1733 for an honest assessment.
Asphalt paving runs $3,500 – $9,000 in San Fernando, and full replacement with base work runs $5,000 – $14,000. Sealcoat is a separate $250 – $700 line when it comes due. Call (888) 427-1733 for an exact quote; estimates are free and come in writing.
Every asphalt driveway project we install is covered by our 730-Day Done Right Promise: if the workmanship fails, we make it right. That’s one of the longest workmanship guarantees in the residential construction space, and it’s in writing. Call (888) 427-1733 for details on your project.
Get a Free Estimate for Asphalt Driveways & Resurfacing in San Fernando
Call (888) 427-1733 to schedule a free on-site estimate for your asphalt driveway in San Fernando. A live person answers, day or night, and we’ll set a time that works. On the visit we measure the drive, check the base, and hand you a written line-item quote with fixed pricing, the 730-Day Done Right Promise, and no surprises after work starts. We cover San Fernando and the surrounding Valley. Homeowners often pair a new driveway with New Detached ADU in San Fernando or a Junior ADU & Interior Conversion in San Fernando when they’re upgrading the property all at once.
Written by the team at Groundwork Construction Co.