Driveway & pavers
Kitchen remodeling
Bathroom remodeling
Home additions & ADU
Roofing
Windows & doors
FenceFree written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
IKO Driveway & Pavers: The Los Angeles Owner’s Guide
We install and repair IKO-compatible driveway and paver systems across Los Angeles, and a full paver driveway installation typically runs $8,260 – $21,240 depending on square footage, base preparation, and paver selection. Driveway replacement runs $5,900 – $16,520, and sealing alone runs $295 – $825. The price you see is the price you pay – our upfront pricing means no surprises once the work starts. We’re an independent service provider, not affiliated with IKO.
Most Los Angeles owners don’t discover a paver or base failure from a dramatic event. They notice it slowly: a low spot that holds water after a winter rain, a few pavers at the apron that shift when the car rolls over them, or sand joints that wash out faster every year. By the time the first paver rocks underfoot, the bedding layer underneath has usually been moving for a season.
Which IKO Models This Applies To
IKO’s driveway and paver line covers interlocking concrete pavers, permeable systems, and the base and joint materials that hold them together, and each product family carries its own thickness, edge-profile, and compaction requirements. Before you order a single replacement paver, pull the product label or the original spec sheet from the contractor’s packet. The three things that matter most are the paver’s nominal thickness (common ranges run from about 2 3/8 inches for pedestrian use up to 3 1/8 inches for vehicular driveways), the surface finish or texture, and the color lot. A paver that matches thickness but comes from a different run will read as a slightly different shade once the whole field is wet.
Pull a single paver from a corner and measure it. Note the length, width, and thickness in millimeters, then photograph the back where the manufacturer stamp or mold number usually sits. That’s the data we need to match the part correctly.
On the OEM-versus-aftermarket question, we tell Los Angeles homeowners the truth: for pavers, the “OEM” line matters most for color and finish matching. Structural compatibility is about thickness and edge profile, which are standardized enough that a quality aftermarket paver can substitute if the base is rebuilt to spec. For the base materials, joint sand, and polymeric joint stabilizers, aftermarket equivalents from a reputable supplier perform as well or better than a branded package. We don’t claim to stock IKO parts; we source them through verified suppliers for your specific job and quote you a written line item for each material.
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
Signs Your IKO Driveway & Pavers Is Failing
- Pavers rocking or “chunking” under the tire path. This happens when the bedding sand has migrated or the base wasn’t compacted in lifts. In Los Angeles, our clay-heavy soils near Echo Park and Silver Lake expand and contract with wet winters and dry summers, and the base layer often fails before the pavers do.
- Joint sand washing out within a month of installation. Sand that disappears quickly points to missing edge restraint or a low joint fill. Los Angeles rain doesn’t fall often, but when it does, water finds the weakest edge on the driveway.
- A low spot or “birdbath” that holds water after rain. Standing water is the first sign the base has settled. Left alone, it works its way into the subgrade and spreads.
- Efflorescence – the white, chalky film on paver surfaces. Some efflorescence is normal in the first season as soluble salts rise to the surface. On an older driveway, recurring efflorescence can signal water pooling beneath the field.
- Edge restraint or curb pulling away from the driveway border. That curb holds the whole field in compression. Once it moves, the pavers near it loosen and the failure creeps inward.
See the difference
Before
After
Before
After
Before
AfterReplacement Cost & What’s Included
Installed pricing for Los Angeles runs in these ranges, and every quote we write is line-item transparent so you can see what’s material and what’s labor:
- Paver driveway installation: $8,260 – $21,240
- Driveway replacement: $5,900 – $16,520
- Concrete driveway installation: $5,310 – $14,160
- Asphalt driveway paving: $4,130 – $10,620
- Driveway sealing: $295 – $825
- Paver patio installation: $4,130 – $12,980
What moves you within that range: driveway square footage, how much base has to be excavated and recompacted, whether you need new edge restraint or a drainage channel, and paver selection. Sealing is a separate line because the driveway has to cure first. Every Groundwork project is covered by the 730-Day Done Right Promise – if it’s not done right, we make it right. That’s the warranty on the workmanship and the finish, and it’s written into the agreement.
DIY or Call Us?
Here’s the honest split. You can safely check a few things yourself: print the product label from your paver box or contractor packet, photograph the exposed back of a paver for the mold number, measure thickness and length, and check for soft spots by walking the full driveway. That’s a five-minute diagnostic and it makes the estimate conversation far faster.
What we don’t recommend is a DIY re-set on a failed section. Lifting pavers and refilling with sand seems simple, but the second you pull out the joints, the compaction of the base beneath the field is exposed and can shift. A homeowner who refills from the top without recompacting the base and resetting edge restraint usually sees the same paver fail again within a year, and now the fix scope is larger. Lifting and resetting pressure-placed pavers is a job for a trained crew that knows the compaction spec, the joint sand, and the base material for Los Angeles soils specifically.
When you’ve got the label and measurements in hand, give us a call at (888) 427-1733 and we can talk through what’s failing and what a fix actually involves. Calls are answered by a live person, 24/7 – no voicemail, no waiting until Monday morning.
FAQs
How long should IKO pavers last on a Los Angeles driveway? A properly installed IKO paver driveway should hold for 25 to 30 years or more in our climate, but base failure is what shortens that – and in Los Angeles, clay soils under a poorly compacted base can fail within 5 to 10 years. The pavers themselves almost never wear out first. Call (888) 427-1733 for an exact quote – estimates are free.
Can you repair failing pavers instead of replacing the whole driveway? Yes, many failures are isolated to a section or to the edge restraint, and repairing that zone – typically under $1,000 for a spot fix – is often the right call. Lifting and re-setting failed pavers with fresh base material and new joint sand can be a focused job. The one prompt to consider full replacement: if the low spots, rocking, or joint washout are spread across the whole field. Call (888) 427-1733 for a free estimate, and we’ll tell you honestly which one you need.
How long does a paver repair or replacement take? A spot repair on a driveway section typically takes most jobs completed in a single visit, often under one day, once the parts and materials are on site. A full paver driveway installation usually runs 3 to 5 working days, weather permitting, and repairs can only start after the IKO-compatible paver color lot is confirmed. Call (888) 427-1733 to get the schedule started.
How do you source the IKO part? We don’t claim to stock IKO parts, and we don’t tell you a truck carries them. We source the specific paver, base material, edge restraint, and joint sand through verified supplier channels once we’ve matched the part to your job and measurement. You’ll see the line item for each on your written estimate before a shovel hits the ground. Our technicians have up to 12 years of experience with paver systems, and we also work with trusted brand partners including Belgard, James Hardie, and – for interior work you might be considering alongside a driveway refresh – KraftMaid, Cambria, and Silestone. Call (888) 427-1733 for your free estimate.
Written by the team at Groundwork Construction Co. of Los Angeles, serving Los Angeles and nearby areas.