Driveway & pavers
Kitchen remodeling
Bathroom remodeling
Home additions & ADU
Roofing
Windows & doors
FenceFree written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Oldcastle Driveway & Pavers: The Los Angeles Owner’s Guide
We install and repair Oldcastle-compatible driveways and paver systems across Los Angeles, and the number most homeowners want first is this: paver driveway installation typically runs $8,260 to $21,240 installed, while repair and re-laying of a failing section usually lands far below the low end. We give you a written line-item estimate so you see materials, labor and disposal separately. Most residential paver jobs are completed in a single visit once we’ve matched your existing product, and every job is covered by our 730-Day Done Right Promise.
Owners usually discover the failure the same way. A driveway that used to shed water starts pooling after a storm. A paver near the apron lifts a half-inch and trips the mail carrier. Or a section of pavers sitting over your front walkway turns loose and starts rocking underfoot. In Los Angeles, where we go months without rain and then get a concentrated downpour, drainage problems hide until the first real storm turns them into a visible failure.
Key Takeaways
- Paver driveway installation in Los Angeles: $8,260 to $21,240 installed.
- Oldcastle paver systems come in family lines with specific size and thickness specs; the right match depends on your existing course.
- Most paver repairs and re-lays finish in a single visit.
- We are an independent service provider, not part of Oldcastle.
Which Oldcastle Models This Applies To
Oldcastle is a large building products company, and its hardscape lines reach the market under a handful of brand families rather than one universal “Oldcastle paver.” That matters the moment you need a replacement piece, because the exact size, thickness and color of your existing pavers have to match the new ones, or you’ll see a visible seam where the repair meets the field. The most common spec ranges for residential paver systems are nominal thicknesses of about 60mm to 80mm for driveways and about 40mm to 60mm for walkways and patios; a driveway paver that measures thinner than your field course won’t hold under a vehicle load.
To identify what you have, look at the exposed edge of a paver where it meets the driveway apron or a control joint, then measure its length, width and thickness with a tape. A label on a pallet or a course chart left by the original installer is the fastest confirmation. When the original product is discontinued, we source the closest dimensionally and color-matched equivalent rather than forcing a mismatched piece. That OEM-versus-aftermarket decision is where most driveway paver jobs go wrong: an exact-size aftermarket paver that reads as a compatible match often saves the customer real money compared to tracking down discontinued stock, and we tell you plainly which path we’d take and why before any work begins. This is the same sourcing discipline we apply to KraftMaid, Cambria and Silestone products on our kitchen and bath projects.
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
Signs Your Oldcastle Driveway & Pavers Is Failing
Pavers rarely fail all at once. They telegraph the problem first, and reading the symptoms correctly is what separates a spot repair from a full re-lay.
- Pooling water after rain. Standing water means the base or the slope has shifted, and water is no longer running off the way it should. Left alone, pooled water gets under the field and softens the bedding layer.
- Rocking or loose pavers. A paver that moves underfoot has lost its bedding support, usually from a compacted base that wasn’t deep enough or from water finding a path beneath it. This is the single most common call we get in Los Angeles.
- Sunken sections or settling. Settling over a driveway apron or near a downspout tells you the subgrade is washing out. Los Angeles soil conditions and concentrated runoff are frequent contributors.
- Polymeric sand washing out of the joints. Joint sand that erodes over a season or two lets the pavers shift against each other, and once the joints open, weeds and water follow.
- Faded, chipped or cracked paver faces. Surface wear, spalling at the edges, or visible cracks in individual units mean those pieces are at the end of their service life and need replacement rather than re-sanding.
If you see two or more of these together, especially settling plus pooling water, the problem is almost certainly the base rather than the surface, and re-sanding the joints won’t fix it.
See the difference
Before
After
Before
After
Before
AfterReplacement Cost & What’s Included
Paver driveway installation in Los Angeles runs $8,260 to $21,240, and that range reflects real differences in scope: driveway square footage, whether the existing surface and base have to be removed and hauled off, drainage corrections, and whether you’re matching an existing pattern or laying a new one. A full driveway replacement typically runs $5,900 to $16,520, which is the right comparison when the base itself has failed. Paver patio installation, at $4,130 to $12,980, is the closest line for walkway and patio work.
Our pricing is upfront and line-item, so you see the paver cost, the base prep, the labor and the debris removal as separate numbers – the number you see is the number you pay, and we don’t do change-order surprises once the work is underway. Every job is covered by the 730-Day Done Right Promise, so if a paver settles or a joint fails inside that window, we come back and make it right.
| Line item | Typical Los Angeles range |
|---|---|
| Paver driveway installation | $8,260 – $21,240 |
| Driveway replacement (full) | $5,900 – $16,520 |
| Paver patio installation | $4,130 – $12,980 |
| Driveway sealing | $295 – $825 |
Call (888) 427-1733 for a free estimate with a written line-item quote.
DIY or Call Us?
There’s a safe, useful middle ground here. You can absolutely measure your pavers, photograph the problem area, clear the weeds from open joints, and check where your downspouts discharge – all that information makes our estimate more accurate. What you shouldn’t take on yourself is re-setting a sunken section, correcting the base drainage, or re-laying pavers over a failed subgrade. Those aren’t dangerous like a high-tension garage spring, but getting the base and the slope wrong means the repair fails again within a season, and a paver repair redone twice costs more than one done right. Working over a driveway apron or any area near a slope also warrants a trained eye, because the fix usually isn’t under the paver, it’s under the base.
If your driveway is one of these failure cases anywhere in Los Angeles, give us a call and we’ll tell you honestly whether a spot repair or a full re-lay is the smarter spend. Call (888) 427-1733 to schedule your free estimate.
FAQs
A properly installed paver driveway should give you 15 to 25 years or more, but the base is what decides that number, not the paver face. In Los Angeles, the base takes the real beating from dry-season heat cycling followed by concentrated storm runoff, and a shallow base can fail years before the pavers themselves wear out. Call (888) 427-1733 and we’ll tell you which part of your system is actually at the end of its life.
Yes – if the failure is confined to a small section and the base underneath is sound, a targeted re-lay or re-sand is almost always the better call. When settled sections are widespread or water is pooling over a large area, a full replacement is the honest answer. Call (888) 427-1733 and we’ll assess it without pushing the more expensive option.
Most residential paver repairs and section re-lays finish in a single visit; a full driveway replacement usually takes a few days once the base, drainage and setting work are accounted for. We’ll tell you the expected timeline in your written estimate, before any work starts. Call (888) 427-1733 for an exact schedule.
We identify your existing paver by measuring its length, width and thickness and reading any course or pallet label, then source an exact or dimensionally matched product through our verified brand partners. When the original line is discontinued, we’ll show you the closest color and size match and explain the difference before you commit. Call (888) 427-1733 to get the match and the price in writing.
Groundwork Construction Co. of Los Angeles is an independent service provider and is not affiliated with Oldcastle. We handle Oldcastle-compatible driveway and paver work, and we also work with KraftMaid, Cambria and Silestone products on our kitchen and bath projects. Every job is backed by the 730-Day Done Right Promise, our calls are answered by a live person 24/7, technicians are background-checked and arrive in uniform, and we offer upfront pricing with $1,000 off projects over $10,000 plus 0% financing for 18 months. Call (888) 427-1733 to schedule your free project estimate and design consult.
Written by the team at Groundwork Construction Co. of Los Angeles, serving Los Angeles and nearby areas.