Windows & doors
Kitchen remodeling
Bathroom remodeling
Home additions & ADU
Roofing
Driveway & pavers
FenceFree written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Impact Windows & Doors in El Segundo: What the Job Actually Involves
Impact window and door installation in El Segundo runs $8,000 – $25,000 for a typical home, and most projects take two to four weeks from signed contract to final inspection. The work means pulling the old units, reframing where the opening has shifted, setting laminated-glass assemblies rated for wind-borne debris, sealing every penetration against salt air, and passing city inspection. Call (888) 427-1733 to schedule a free on-site estimate. We’ll measure the actual openings, not guess from a photo.
How We Run an Impact Windows & Doors Project, Stage by Stage
This isn’t a one-day swap. Here’s the real sequence we follow on El Segundo homes, and where you make decisions along the way.
Stage 1: Measure and verify (day 1, about 90 minutes)
We open every window, check the door swings, and measure rough openings against the manufacturer’s spec sheet. On 1940s bungalows west of Sepulveda, that often means discovering a previous remodel furred out a wall by an inch or that a slider was set out of square. You decide the glass package and frame color at this stage, because lead times run three to five weeks on impact-rated units.
Stage 2: Permit and product order (week 1)
We submit to the city building department and place the order the same week. Plan-check comments on a small residential job typically come back inside a few business days here rather than sitting in a county queue. You sign off on the final product list and confirm the delivery window.
Stage 3: Protection and demo (day 1 of install, 4 – 6 hours)
Floors get covered, furniture gets moved, and each opening is opened up one at a time rather than stripping the whole house at once. That matters in El Segundo because you need at least one secured, weather-tight opening overnight. Old units come out, and we inspect the framing and flashing behind them.
Stage 4: Setting, shimming and sealing (days 2 – 3)
New assemblies go in plumb and level, shimmed at the jambs, then sealed with corrosion-rated flashing and a marine-grade sealant. Coastal air eats cheap fasteners, so we don’t use them. This is the slow part, and we don’t rush it.
Stage 5: Trim, hardware, inspection and walkthrough (day 4)
Interior trim goes back, door hardware and rolling-code remotes get programmed, and the city inspector signs off. We walk the job with you, show you the operation of every unit, and hand over warranty paperwork tied to our 730-Day Done Right Promise.
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
The Options You’ll Actually Choose Between
- Frame material: vinyl vs. aluminum vs. fiberglass. Vinyl is the value pick and handles salt air fine at the low end of the range. Aluminum is slimmer and suits the mid-century look but conducts heat. Fiberglass holds up best near the coast and costs the most.
- Glass package. Laminated impact glass is the baseline. Adding a low-E coating helps with west-facing afternoon sun and a laminated-plus-insulated unit cuts street noise near Sepulveda.
- Door type. Entry doors rated to impact spec, sliding patio units, and security-focused openers with rolling-code remotes. Townhome and alley-load doors need tighter clearance checks before ordering.
- Color and finish. Anodized finishes resist corrosion better than painted ones in marine air. Painted is cheaper and matches trim faster.
- Hardware grade. Stainless and marine-rated hardware add cost but last far longer two blocks from the water.
Modular and prefab builders like Abodu and Mighty Buildings use factory-set impact glazing, which is worth knowing if you’re adding a unit rather than retrofitting an existing house.
What Impact Windows & Doors Cost in El Segundo, CA
Expect $8,000 – $25,000 for a whole-house impact window and door package here. A single opening replaced runs toward the low end; a full bungalow with eight windows and two doors plus a slider pushes toward the ceiling.
What moves the number:
- Count and size of openings. Each unit carries its own product and labor line.
- Condition of the existing framing. Rotted sills or out-of-square openings from older remodels add reframing hours.
- Glass and frame grade. Fiberglass and laminated-plus-insulated units cost meaningfully more than basic vinyl.
- Door complexity. A security door with a rolling-code opener and tighter townhome clearances adds to the total over a standard entry door.
- Permit scope and access. Controlled-access or alley-load sites take extra scheduling, and that shows up in labor.
Your written estimate is line-item: product, labor, permit, disposal, trim. What’s usually outside it: structural repair discovered after demo, stucco patching beyond the opening, and interior painting. Upfront pricing, no surprises.
See the difference
Before
After
Before
After
Before
AfterWhat El Segundo Homes Specifically Do to This Job
Most of the housing stock here is 1940s – 1950s bungalows and post-war tract homes on 5,000 – 6,000 sq ft lots built for aerospace workers, and that era shows up in the framing the moment you pull a window. Openings weren’t built to today’s tolerances, so reframing is normal, not exceptional. Near the Raytheon campus and the east side, controlled-access and badging rules change how we schedule deliveries, so we plan material drops around it. The marine layer off Santa Monica Bay is the other factor: salt-laden air corrodes fasteners, flashing and door hardware faster than inland, which is why corrosion-rated materials are a real line item rather than an upsell. Permits run through the city’s own small, detail-oriented building department, and comments come back fast and personal. Homeowners often pair this with Aluminum Fence in El Segundo work to secure the same perimeter.
Serving El Segundo, CA – Our Local Coverage Area
We serve El Segundo and nearby communities. Use the map below to see the area we cover. If you’re nearby, we can almost certainly help.
Frequently Asked – Impact Windows & Doors in El Segundo
Two to four weeks from signed contract to final inspection, with three to five of those weeks being product lead time. Install itself is usually four days. Call (888) 427-1733 for a schedule based on your actual opening count.
Yes, replacement and new openings require a permit through the city building department. We pull it and manage the inspection. Call us and we’ll walk you through what the plan check involves for your address.
In most cases yes, because we work within the existing openings and only reframe where the rough opening is out of spec. If a wall has to move, that’s a separate scope we’ll flag before you sign anything.
Between $8,000 and $25,000 depending on count, glass grade and framing condition. Call (888) 427-1733 for an exact figure – estimates are free.
Our workmanship is backed by the 730-Day Done Right Promise, and manufacturer warranties cover the units themselves. If something isn’t right, we make it right. Call to see the written terms.
Get a Free Impact Windows & Doors Estimate in El Segundo
We’ll come out, measure the real openings, and hand you a line-item estimate at no cost. It’s part of a full Windows & Doors in El Segundo scope if you’re planning more than impact units. We answer live, 24/7, at (888) 427-1733. Our Windows & Doors service covers everything from door hardware to full assemblies, and we work throughout El Segundo. Homeowners often pair the job with Iron Fence in El Segundo for the same security upgrade. Call today.
Written by the team at Groundwork Construction Co.