Driveway & pavers
Kitchen remodeling
Bathroom remodeling
Home additions & ADU
Roofing
Windows & doors
FenceFree written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Paver Driveways in Calabasas, CA: What the Job Actually Involves
Paver driveways in Calabasas typically run $7,000 – $18,000 and take three to six days start to finish, depending on square footage, slope, and how much base work the site needs. The short version: we demo and haul off the old surface, excavate and compact a structural base, set the pavers on a sand bed with edge restraint, cut in the aprons, then sweep in joint sand and compact again. Call (888) 427-1733 and we’ll walk your actual driveway before quoting a number.
How We Build a Paver Driveway, Stage by Stage
Every driveway we take on gets the same sequence, adapted to the grade. Here’s what actually happens on your property, and when you’re the one making a call.
Stage 1: Site visit and layout (day one, 90 minutes)
We measure the driveway footprint, check the existing base depth with a probe, and look at where water runs when it rains. On a sloped lot off Mulholland Heights or a canyon road, we note the fall of the grade and where a drainage channel or French drain will need to sit so water doesn’t sheet toward the garage. This is where you decide the paver style and lay pattern; we don’t order material until you’ve signed off on a sample.
Stage 2: Demo and excavation (days one and two)
Existing concrete, asphalt, or gravel comes out and gets hauled to a transfer station. We excavate to a compacted depth of roughly 8 – 12 inches on standard residential loads, deeper where a delivery truck or RV will park. If the lot is cut into a hillside, this is the stage where surprises show up: buried tree roots, old footings, or a slope that needs a low retaining curb at the low side. We flag those before we keep digging and price them in writing.
Stage 3: Base, compaction, and edge restraint (day two into three)
We lay a compacted aggregate base in two lifts, each watered and plate-compacted, then screed a bedding layer of coarse sand. Edge restraint goes in pinned to the base on both sides. This is the part nobody sees and the part that decides whether the driveway still looks flat in year ten. The homeowner decision here is minor: we confirm the final elevations so the driveway meets the apron and garage slab without a lip.
Stage 4: Paver setting and cutting (days three and four)
Pavers go down in the pattern you chose, then we wet-saw the border, the apron, and any curves. Expect noise and a fair amount of dust on cut days. You’ll want to keep vehicles off the street apron while we’re cutting, and we’ll tell you the day before so you can move cars.
Stage 5: Joint sand, compaction, and walkthrough (final day)
Polymeric or regular joint sand gets swept in and the whole surface is compacted a final time. We do a walkthrough with you, hose it down so you can see the true color, and leave you written care instructions. Sealing, if you want it, happens after the pavers cure – usually a few weeks later – and we’ll tell you the honest window.
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
The Options You’ll Choose Between
Most of the decisions on a paver driveway come down to three things: material, thickness, and pattern. Here’s how each one actually plays out.
- Concrete pavers (the default): The most common choice for Calabasas driveways. Interlocking units in a range of colors, with a tumbled or smooth face. They handle the heat, hold up to tire traffic, and a single cracked unit can be lifted and swapped without tearing out the whole drive. Belgard makes a solid line here and it’s one we install regularly.
- Clay brick pavers: Warmer color, classic look, and a genuinely long service life. The trade-off is cost – they run higher per square foot than concrete – and they’re heavier, so installation takes longer. A good fit for the Mediterranean-style estates around The Oaks where the palette calls for it.
- Permeable pavers: Open-joint or gapped systems that let water drain through the base instead of running off. Worth considering on canyon lots where runoff and erosion are real concerns, and where the slope pushes water toward a neighbor. Higher material cost, but they solve a drainage problem a solid surface can’t.
- Thickness: 60mm units are standard for a residential driveway. Step up to 80mm where an RV, boat, or heavy truck parks regularly.
- Pattern and border: Running bond, herringbone, and basketweave are the common choices. A contrasting border and a soldier course at the apron cost a bit more in material and labor but change the whole look. This is the one place to spend a little extra if curb appeal is the goal.
- Sealing: Optional. Sealer deepens color and slows staining but needs reapplying every few years. It’s not required, and we won’t push it.
What Paver Driveways Cost in Calabasas, CA
Paver driveway installation in Calabasas runs $7,000 – $18,000 for a typical residential drive. Here’s what pushes a job toward the low or high end.
- Square footage: A standard two-car drive sits near the low end. A long driveway or a circular turnaround on a canyon lot pushes toward the top.
- Slope and site access: Hillside lots need more excavation, drainage work, and sometimes a retaining curb. Tight canyon access that slows hauling and delivery adds labor.
- Existing surface: Tearing out old concrete costs more than removing gravel. A driveway that needs a full re-base costs more than one with a sound base underneath.
- Material grade: Concrete pavers are the value pick; clay brick or permeable systems run higher per square foot.
- Permit scope: Most driveway resurfacing doesn’t need a building permit, but anything that changes grading, drainage, or the apron at the street may require a city review or encroachment permit – and on a hillside lot, that review can add time and cost.
A written estimate from us itemizes demo, haul-off, base material, pavers, edge restraint, and joint sand, so you can see where every dollar goes. What’s typically not included unless we call it out: major drainage upgrades, retaining wall construction, and any repair to a garage slab or apron that’s failing underneath.
See the difference
Before
After
Before
After
Before
AfterWhat Calabasas Homes Specifically Do to This Job
Calabasas sits in the Santa Monica Mountains foothills, and that single fact reshapes most paver driveway work here. Hillside and canyon lots mean grading, slope-stability, and drainage are part of the job before a single paver goes down – flatland crews from the Valley who don’t deal with grade every day tend to underestimate it. The City’s hillside and oak-tree ordinances matter too: a coast live oak near the drive can trigger an arborist report and setback requirements that change the layout.
The housing stock splits roughly two ways. On the gated estates in The Oaks, Calabasas Hills, and Mulholland Heights, we’re usually matching a premium finish to a Mediterranean or Spanish-style facade, with borders and colors picked to complement stucco and clay tile. In the older 1960s-70s ranch homes and the canyon rebuilds, we’re more often replacing a worn concrete or asphalt drive with something that handles the grade and the summer heat better. After the Woolsey Fire, rebuilds in the canyons also bring WUI code considerations into the site plan – driveways need to serve as defensible access for fire apparatus, which can affect width and turnaround. The ZIP codes we cover here are 91302 and 91372, and we work across Calabasas and the surrounding canyons.
Serving Calabasas, CA – Our Local Coverage Area
We serve Calabasas and nearby communities. Use the map below to see the area we cover. If you’re nearby, we can almost certainly help.
Frequently Asked – Paver Driveways in Calabasas
Most paver driveways in Calabasas take three to six working days, from demo through final compaction. A simple flat drive can finish in three; a hillside job with extra excavation, drainage, or a long run pushes toward the six-day end. Call (888) 427-1733 for a timeline specific to your property.
Often no – a straight resurfacing over an existing drive usually doesn’t require a building permit. But if the work changes grading, affects drainage, or touches the apron and street right-of-way, the City may require review or an encroachment permit, and hillside lots get more scrutiny. We identify what’s required and pull what’s needed as part of the job. Call (888) 427-1733 to talk through your site.
Paver driveway installation in Calabasas runs $7,000 – $18,000, with the number driven by square footage, slope, existing surface, and material choice. Call (888) 427-1733 for a free on-site estimate with a written, itemized price.
In most cases, yes – a paver driveway replaces the surface and base only, so established plantings at the edges and buried utilities stay put. We locate utilities before we dig; if a line sits in the excavation path, we’ll tell you before work starts rather than after. This is a common concern for homeowners who pair a new drive with a larger project, and it’s one we plan around. Call (888) 427-1733 to schedule a look.
Every paver driveway we install is covered by our 730-Day Done Right Promise – if it’s not done right, we make it right. That’s one of the longest workmanship guarantees in residential construction, and it’s in writing. Material warranties come from the paver manufacturer and vary by product. Call (888) 427-1733 to review the details.
Get a Free Paver Driveway Estimate in Calabasas
We’ll come out, measure the drive, look at the grade and drainage, and give you a written, itemized price before any work starts. No pressure and no vague ballpark – the number you see is the number you pay. A new driveway is often part of a full Driveway & Pavers in Calabasas project, and homeowners frequently pair the work with Garage Conversion ADU in Calabasas or ADU Design & Permitting in Calabasas, so we can scope those together if you’re planning more. Explore our full Driveway & Pavers service, then call (888) 427-1733 – a live person answers, 24/7.
Written by the team at Groundwork Construction Co.