Windows & doors
Kitchen remodeling
Bathroom remodeling
Home additions & ADU
Roofing
Driveway & pavers
FenceFree written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Sliding & Patio Doors in Malibu: What They Cost and How They Hold Up
Replacing a sliding or patio door in Malibu typically runs $3,200 to $11,500 installed, depending on width, glazing, and whether the opening needs reframing. Most single-door swaps take two to three days from demo to final seal; a multi-panel or corner system runs four to six. Call (888) 427-1733 and we’ll walk the opening, check the header and track, and put a written number in front of you before anything gets ordered.
How We Install or Replace a Sliding & Patio Door, Stage by Stage
Every job starts with the opening, not the door. Here’s the sequence we follow on Malibu homes.
- Day 1, morning – site walk and measurement. We check the rough opening for square, probe the header for rot, and confirm the threshold height relative to the deck or patio slab. On bluff and canyon lots we also look at how the door sits against any wind-load or fire-hardening detailing already in place. You decide here whether we’re matching the existing opening exactly or reframing for a wider panel.
- Day 1, afternoon – order and permit. Once the size and glazing package are locked, we place the order and, where the scope requires it, pull the permit. Lead times on custom sizes and impact-rated units run longer than stock, so this is the stage that sets your calendar. You’ll get a written line-item quote before we order a single panel.
- Day 2 – demo and prep. The old door comes out, the opening gets cleaned back to framing, and any soft wood or failed flashing gets replaced. We check the sill pan and drainage path, which matters more than people expect on hillside homes where water wants to run toward the house.
- Day 3 – set, seal, and finish. The new unit goes in plumb and square, gets shimmed and fastened per the manufacturer’s spec, then flashed, sealed, and trimmed. We test the slide, check the lock engagement, and confirm the screen or panel tracks clean.
- Final walkthrough. You operate the door yourself, we hand over the warranty paperwork, and anything that needs a return visit gets scheduled on the spot. Most jobs finish in a single visit once materials are on site.
If the door replacement is part of a full Windows & Doors in Malibu scope for the same wall, we sequence the openings together so the exterior gets sealed once and the trim lines match.
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
The Door Options You’ll Actually Choose Between
The material and glazing choices drive both the price and how the door behaves in coastal weather. Here’s the honest trade-off on each.
- Vinyl sliding doors. The value pick at the low end of the range. Won’t rot, needs little upkeep, and handles salt air well. The trade-off is that vinyl is less rigid over very wide spans, so it suits standard six- to eight-foot openings better than a wall of glass.
- Aluminum with a thermal break. Slim frames and larger glass panels. Good for contemporary hillside homes that want maximum view. You pay more, and the frame conducts heat unless it’s thermally broken, so specify that or skip it.
- Wood-clad and fiberglass. Warm interior look with a weather-resistant exterior skin. Fiberglass holds up to sun and salt spray better than wood alone. These land in the middle-to-upper range and pair naturally with Andersen or Marvin units if you want a name brand behind the warranty.
- Impact-rated glazing and wind-rated assemblies. The resilience choice. Laminated impact glass resists wind-borne debris, and a properly rated assembly holds the opening under high wind. It costs more per panel but is the right call on exposed frontage.
- Multi-panel and corner systems. Sliding walls and corner units that open the whole room. Dramatic, but they need a solid header and careful structural planning, which pushes the price toward the top of the range.
We’ll show you samples and explain where each one makes sense for your wall before you commit.
What Sliding & Patio Doors Cost in Malibu, CA
Most Malibu sliding and patio door projects land between $3,200 and $11,500. A standard single sliding door swap sits near the bottom; a wide multi-panel or impact-rated system sits near the top. Here’s what moves the number:
| Line item | Typical range |
|---|---|
| Standard sliding door (supply + install) | $3,200 – $5,800 |
| Fiberglass or wood-clad unit | $5,000 – $8,000 |
| Impact-rated / wind-rated assembly | $6,500 – $11,500 |
| Reframing or header repair | $600 – $2,400 |
| Permit and inspection | varies by scope |
- Size. A six-foot opening and a twelve-foot multi-panel wall are different projects. Width and panel count are the biggest single lever.
- Existing condition. Rot in the header, a failed sill pan, or a threshold that’s dropped below the slab adds repair time before the new door goes in.
- Glazing package. Impact-rated and low-E laminated glass cost more than standard clear glazing but change how the door performs.
- Structural work. Widening an opening or converting a fixed window into a sliding door means framing and header changes, which pushes toward the high end.
- Permit scope. A like-for-like swap and a structural change aren’t the same paperwork. We confirm which applies before we quote.
A written estimate lists the door unit, labor, disposal, flashing and sealant, trim, and the permit line if one applies. It won’t include surprise add-ons – the number you see is the number you pay, and the work is backed by the 730-Day Done Right Promise.
See the difference
Before
After
Before
After
Before
AfterWhat Malibu Homes Specifically Do to a Sliding & Patio Door Job
Malibu construction is shaped by the Santa Monica Mountains meeting the Pacific. Nearly every project is a hillside or bluff-edge build, and coastal development permits, geotechnical slope stability, and fire-hardening requirements shape the design before a permit is pulled. The fire-prone chaparral interface means noncombustible exterior components and ember-resistant detailing are standard, so a door’s rating and how it’s sealed against the wall genuinely matter here, not just how it looks.
Salt spray and Santa Ana wind events push material choices. Corrosion-resistant fasteners and marine-grade exterior hardware are routine on our Malibu jobs, and we see more blown-out tracks and bent panels from wind events than from any other cause. Canyon roads like Latigo and Encinal are the only access for many hillside sites, so material deliveries get scheduled around narrow, winding grades, and Coastal Commission approval can add months before foundation-level work begins. On the PCH frontage and the bluffs above Zuma, we regularly find mid-century sliding doors with failed seals and rusted tracks where wind and salt have done the damage. Homeowners often pair a door replacement with Fence Repair in Malibu after the same wind event, and sometimes with Paver Driveways in Malibu when the patio and approach need the same attention.
Our windows & doors service covers the full scope if you want to treat the whole exterior wall at once, and we work across Malibu including the 90265, 90263, and 90264 ZIPs.
Serving Malibu, CA – Our Local Coverage Area
We serve Malibu and nearby communities. Use the map below to see the area we cover. If you’re nearby, we can almost certainly help.
Frequently Asked – Sliding & Patio Doors in Malibu
A standard single sliding door replacement takes two to three days once materials are on site, and a multi-panel or impact-rated system takes four to six. Custom sizes and lead times on specialty glass push the calendar more than the install itself. Call (888) 427-1733 for a schedule based on your opening.
It depends on whether the opening changes. A like-for-like replacement of the same size usually doesn’t require a structural permit, but widening the opening or changing the header does, and coastal and fire-hardening requirements can add review. We confirm the permit scope before we quote so there are no surprises mid-job. Call (888) 427-1733 to talk through your project.
Yes, in most cases – if the opening is the same size, we set the new unit in the existing frame with no structural work. Converting a window to a door or widening the opening does involve framing and a header change, which we scope and price separately. A walkthrough tells us which situation you’re in.
Plan on $3,200 to $11,500 installed, with a standard swap near the low end and an impact-rated multi-panel system near the high end. Reframing or header repair adds $600 to $2,400. Call (888) 427-1733 for an exact quote – estimates are free.
Every sliding and patio door project is covered by our 730-Day Done Right Promise: if it’s not done right, we make it right. The door unit itself also carries the manufacturer’s warranty, which we hand over at the final walkthrough. Calls are answered by a live person 24/7, so a question about a track or a seal doesn’t wait until Monday.
Get a Free Sliding & Patio Door Estimate in Malibu
Call (888) 427-1733 to schedule a free on-site estimate for sliding and patio doors in Malibu. We’ll measure the opening, check the header and track, and hand you a written line-item quote with the door options laid out side by side. A live person answers around the clock, and estimates cost nothing. Financing is available at 0% for 18 months, with $1,000 off projects over $10,000.
Written by the team at Groundwork Construction Co.