Kitchen remodeling
Bathroom remodeling
Home additions & ADU
Roofing
Windows & doors
Driveway & pavers
FenceFree written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Door Installation in Malibu, CA: What It Takes and What It Costs
Door installation in Malibu runs $1,200 to $6,500 per door depending on material, size, and whether we’re cutting a new opening or swapping an existing one. A standard interior door swap takes a single day; an exterior entry door with new framing, flashing, and coastal hardware typically takes two to three days. Call (888) 427-1733 for a free on-site estimate. We’ll measure, check the rough opening, and give you a written line-item number before anything gets demoed.
How our Door Installation Process Works, Stage by Stage
Door work looks simple from the street. In a Malibu house it rarely is. Here’s the actual sequence we run, and where you make decisions.
Stage 1: Site visit and rough-opening check (day 1, about 90 minutes)
We measure the existing opening, check the frame for rot or settling, and test whether the wall is plumb. On bluff-edge and hillside homes we also look at how the door sits relative to the drainage plane, because a door that leaks is almost always a flashing problem, not a door problem. You decide the door style and material at this visit or shortly after; everything downstream depends on it.
Stage 2: Ordering and lead time (3 to 8 weeks, depending on the door)
Stock interior doors arrive in about a week. A custom exterior entry, a Dutch door, or anything in a marine-grade finish runs four to eight weeks. We confirm the order spec with you in writing before it’s placed. If you’re coordinating a wider project, the door timeline folds into the Windows & Doors in Malibu schedule so nobody’s waiting on a delivery.
Stage 3: Demolition and prep (half a day per opening)
Old door comes out, trim comes off, and we expose the rough opening. This is where surprises live. Rotted jack studs and water-damaged sill plates turn up often on older PCH-frontage homes, and that’s a same-day fix we price upfront rather than a change order later. We flash and seal the opening before the new door goes in, not after.
Stage 4: Setting, shimming, and hardware (one to two days)
The door gets set plumb, shimmed, anchored, and checked for swing and latch alignment. Hardware, hinges, and locksets go on. On exterior doors in Malibu we use corrosion-resistant fasteners and marine-grade hardware as standard, because salt air eats standard zinc-plated steel. You confirm hardware finish and lockset type at this stage.
Stage 5: Trim, sealant, and final walkthrough (half a day)
We reinstall or replace casing, seal all exterior joints, and test the door through a full open-close cycle. Then we walk it with you and you sign off. A basic interior swap finishes here on day one. A full exterior entry with framing work lands complete by day three.
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
The Door Options You’ll Choose Between
Most of the decisions that matter get made before we order. Here’s the honest trade-off on each.
- Solid wood entry doors: Beautiful, takes stain, can be refinished. Costs more and needs recoating more often in salt air. Suits a mid-century bungalow that’s being restored rather than modernized.
- Fiberglass entry doors: Holds up to sun and salt better than wood, comes in wood-grain textures, and takes paint well. Mid-range cost, low maintenance. The practical pick for most Malibu exterior doors.
- Steel doors: Strong and secure, but we only recommend them where they’re fully sheltered. Salt spray finds every scratch, and a rusting steel door is a losing fight on a bluff lot.
- Marine-grade stainless and coated hardware: Hinges, locksets, and fasteners that survive the marine layer. Costs maybe 20 to 30 percent more than standard hardware and lasts years longer. On an exterior door we treat this as non-negotiable.
- Interior doors (hollow-core vs. solid-core): Hollow-core saves money for closets and low-traffic rooms. Solid-core for bedrooms and bathrooms, for sound control and a better feel. The price gap runs roughly $150 to $400 per door.
- Pre-hung vs. slab: Pre-hung doors come with the frame and install faster. Slab doors reuse the existing frame and cost less in material but take more labor to fit. Pre-hung is the safer call when the old frame is questionable.
What Door Installation Costs in Malibu, CA
Most Malibu door installation jobs land between $1,200 and $6,500 per door. Here’s how the number moves.
- Interior door, swap only: $1,200 to $2,400 per door installed, including hardware and trim.
- Exterior entry door, like-for-like replacement: $2,500 to $4,500, including flashing and marine-grade hardware.
- Exterior entry with framing repair or a new rough opening: $4,000 to $6,500 and up, depending on structural work.
- Sliding or French door sets: priced per opening and often double an entry door. We quote these as part of Windows & Doors work unless it’s a straight door swap.
Four variables push a job from the low end to the high end: door material and grade, the condition of the rough opening once we demo, whether the opening moves, and hardware spec. A fifth is permit scope. Interiors usually don’t need one. New exterior openings or doors that affect the building envelope can, and we pull the permit and pass inspection rather than hand you a problem at resale.
Every written estimate we hand over is line-item: door, hardware, labor, disposal, permit if required. What’s typically not included is structural repair discovered mid-job, which we price in writing and get your approval on before we touch it. Upfront pricing means the number you see is the number you pay.
See the difference
Before
After
Before
After
Before
AfterWhat Malibu Homes Specifically Do to This Job
Malibu construction is defined by the Santa Monica Mountains meeting the Pacific. That shapes a door install more than most people expect. Coastal Commission jurisdiction can govern exterior changes on bluff and hillside lots, and fire-hardening requirements under WUI codes affect what assemblies are allowed. Both get sorted before a permit is pulled, and both can add months to a project on a canyon road where Latigo or Encinal is the only access for a material delivery. We schedule around narrow, winding grades accordingly.
The housing stock matters too. Malibu runs overwhelmingly to detached single-family homes, from mid-century beach bungalows along the PCH frontage to contemporary hillside estates on canyon and bluff lots. In the older bungalows we regularly see spring and hinge hardware on garage doors failing years ahead of schedule because of salt air, and exterior door frames with soft sills from winter rain on steep terrain. The marine layer and salt spray also mean marine-grade fasteners and coated hardware are routine here, not an upgrade we upsell. If the door work is part of a full exterior refresh, homeowners often pair this with a Chain Link Fence in Malibu or a Vinyl Fence in Malibu while we’re already on site.
Serving Malibu, CA – Our Local Coverage Area
We serve Malibu and nearby communities. Use the map below to see the area we cover. If you’re nearby, we can almost certainly help.
Frequently Asked – Door Installation in Malibu
A standard interior door swap takes one day. An exterior entry door runs two to three days once the door is on site, and the order itself is the longest part of the wait. If your door has to be special-ordered in a marine-grade finish, budget four to eight weeks from order to install. Call (888) 427-1733 and we’ll give you a timeline that matches the door you actually want.
Interior door replacements generally don’t require a permit. New exterior openings, or doors that alter the building envelope on a coastal or hillside lot, can require one, and Coastal Commission review may apply. We check the specific requirement for your property before work starts and pull the permit if it’s needed. Call us for a quick read on your situation, free.
Yes, in most cases. A like-for-like swap reuses the existing opening and doesn’t touch plumbing or structure. When the new door is a different width or height, or the opening has to move, that’s where framing comes in. We tell you which category you’re in at the site visit, before any deposit, so there are no surprises mid-job. Call (888) 427-1733 to schedule that visit.
Most installs run $1,200 to $6,500 per door. Interior swaps sit at the low end, exterior entries with framing repair and marine-grade hardware at the high end. Material grade and rough-opening condition are the two biggest swing factors. Call (888) 427-1733 for an exact quote; estimates are free and come in writing.
Every door we install is backed by our 730-Day Done Right Promise: if it’s not done right, we make it right. That’s one of the longest workmanship guarantees in the residential construction space, and it covers our labor and installation, not just the door manufacturer’s warranty. Call (888) 427-1733 and we’ll walk you through exactly what’s covered.
Get a Free Door Installation Estimate in Malibu
We cover Malibu and the surrounding canyons and coast. Call (888) 427-1733 and a real person picks up, any hour. We’ll ask a few questions about the door and the opening, book a free on-site estimate, and hand you a written line-item quote with the price locked in before work starts. No voicemail, no waiting until Monday.
Written by the team at Groundwork Construction Co.