Driveway & pavers
Kitchen remodeling
Bathroom remodeling
Home additions & ADU
Roofing
Windows & doors
FenceFree written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Asphalt Driveways & Resurfacing in Los Angeles: What It Costs and How Long It Takes
Asphalt Driveways & Resurfacing in Los Angeles typically run $4,130 to $10,620 for new paving and $295 to $825 for a full seal and resurface, with most residential jobs finished in two to three days, plus cure time before you park on them. The number that matters most isn’t the square footage; it’s whether we’re paving over a sound base or rebuilding the subgrade under it. Call (888) 427-1733 and we’ll walk your driveway, check the base, and put the scope in writing.
How an Asphalt Driveway Project Actually Runs, Day by Day
This is the part most bids skip, so here it is in order, with the decision points marked.
Day 1: tear-out and grading
We remove the old surface, then dig down to inspect the subgrade. On older Los Angeles properties that means uncovering whatever the last owner buried: flagstone, brick, a second layer of asphalt. Expect four to six hours for a standard two-car drive. You decide nothing today; we photograph the base and show you what we found before anything goes back down.
Day 1 (continued): base and compaction
A proper base is 4 to 6 inches of compacted Class II aggregate, laid in two lifts and machine-compacted. This is where a cheap driveway gets cheap. You choose base thickness here, and we’ll tell you plainly if your soil needs more. In the flats near Culver City and Westchester, the clay-heavy ground sometimes demands an extra inch to keep water from pumping up through the asphalt. Skipping the base is the single most common cause of early cracking.
Day 2: paving
Hot-mix asphalt arrives at 275-300°F and gets laid at 2 to 3 inches compacted for a residential drive. The crew screeds it, rolls it, and shapes the edges. Two to three hours of actual placement for most Los Angeles driveways. You decide the mix grade here: standard 3/4-inch aggregate for a normal residential drive, or a finer mix if you want a smoother finish with less visible texture.
Day 2-3: drainage and transitions
We cut the apron at the sidewalk, set the driveway-to-garage transition, and confirm runoff moves away from the foundation, not toward it. Los Angeles drainage matters because a single winter storm can dump more rain in an afternoon than the whole prior month, and a driveway pitched the wrong way sends it into the garage. You’ll walk the finished grade with us and approve the fall before it cures.
Cure and striping
Asphalt needs 24 to 48 hours before foot traffic and about 7 days before you park on it. That’s not a shortcut we can take. Striping goes down after the mix cools. You decide the layout: clean edge lines, a center divider, or nothing at all. Then we hand you a written record of the base, the mix, and the thickness, so a future homeowner knows exactly what they bought.
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
The Choices You’ll Make on an Asphalt Driveway
Asphalt isn’t one product. The decisions below are the ones that actually change how your driveway holds up and what it costs.
- Hot-mix vs. cold-patch: Hot-mix is the permanent answer and needs a paving crew on site. Cold-patch is a bagged, temporary fix that lasts a season or two. For anything you’ll park on, hot-mix is the only real option.
- Base thickness: 4 inches is the floor for a residential drive; 6 inches is where heavier vehicles and weaker soil belong. The jump adds a meaningful chunk to the price, but it’s the difference between a driveway that lasts and one that cracks in year three.
- Standard vs. finer mix: A finer aggregate gives a smoother, quieter surface with less visible texture but costs a little more. Standard mix is tougher and cheaper. Most Los Angeles homeowners won’t notice the difference until they’re standing on it barefoot.
- Seal coat timing: Fresh asphalt should cure 6 to 12 months before its first seal, then reseal every 3 to 5 years. Sealing too early traps oils and softens the surface. Get the timing right and you add years.
- Permeable asphalt: Porous mix lets water drain through rather than run off, which matters on lots with tight drainage and steep grades. It costs more and needs more base prep, so it’s a fit for specific properties, not most.
What Asphalt Driveways & Resurfacing Costs in Los Angeles, CA
For a typical two-car residential driveway in Los Angeles, new asphalt paving lands between $4,130 and $10,620. A full resurface with a fresh seal coat runs $295 to $825, and a complete replacement, including tear-out and a rebuilt base, falls in the $5,900 to $16,520 range. Those ranges are real; the number inside your specific range depends on five things.
- Square footage: the biggest lever. A single-car drive is near the low end; a long driveway cut into a hillside lot is far over the high end.
- Existing base condition: a sound base means we’re paving on top of it. A failed base means tear-out, haul-off, and new aggregate, which can add thousands.
- Access and haul-off: narrow streets, tight hillside gates, and long carry distances to the street cost money and time.
- Drainage work: French drains, swales, and grade corrections add cost, but they protect your foundation and are not optional on a sloped lot.
- Permit scope: anything touching a sidewalk apron or the public right-of-way pulls a permit, and we handle that with the city.
A written estimate from us is line-itemed: tear-out, base, mix, thickness, drainage, striping, disposal. What’s typically not included on any honest bid: unforeseen subgrade work found after tear-out, and tree-root grinding near the drive. We tell you both before we start, and the number we write down is the number you pay, backed by our 730-Day Done Right Promise.
See the difference
Before
After
Before
After
Before
AfterWhat Los Angeles Homes Specifically Do to This Job
Los Angeles is a patchwork of housing stock, and it shows up in the driveway work. The 1920s-40s Spanish Colonial and Craftsman bungalows on the flats often still have their original concrete pads, sometimes poured over old brick or flagstone we find only after tearing out. The postwar 1950s-60s stucco tract homes tend to have sound bases but thin, sun-baked surfaces that are ready for a rebuild. And the hillside homes in the Santa Monica Mountains and Hollywood Hills demand grading and drainage work that a flat-lot driveway never touches.
The Los Angeles climate is the other factor. A Mediterranean rhythm of long dry summers and occasional heavy winter rain on steep, fire-scarred slopes means the ground can move, and a driveway pitched wrong sends that water somewhere it shouldn’t go. On hillside lots we plan drainage before we plan the surface, because in Los Angeles a driveway that ignores grade is a driveway you’ll be repairing within a few years. Add the seismic reality of building on a fault-adjacent basin, and the ground under your drive is never a given. That’s why we inspect the base rather than assume it.
Homeowners who are reworking the property often pair a new driveway with New Detached ADU in Los Angeles or a Junior ADU & Interior Conversion in Los Angeles, and we sequence the paving last so the heavy trucks don’t tear up a fresh surface. When the driveway is one piece of a larger exterior plan, the full Driveway & Pavers in Los Angeles scope is the right place to start. We work across Los Angeles and the surrounding communities, and you can see our wider Driveway & Pavers service if you’re weighing asphalt against pavers or concrete.
Serving Los Angeles, CA – Our Local Coverage Area
We serve Los Angeles and nearby communities. Use the map below to see the area we cover. If you’re nearby, we can almost certainly help.
Frequently Asked: Asphalt Driveways & Resurfacing in Los Angeles
Most residential jobs run two to three working days, then 24 to 48 hours before foot traffic and about 7 days before you park on it. Tear-out, base prep, and paving all happen in that window; the cure time is the part nobody can rush. Call (888) 427-1733 and we’ll give you a realistic schedule for your driveway.
If your project touches the sidewalk apron or the public right-of-way, yes, and we pull that permit and handle the inspection. A resurface or a driveway entirely within your property usually doesn’t. Call (888) 427-1733 and we’ll tell you which side of that line your job falls on.
Sometimes. If the base is sound and the surface is only lightly cracked, an overlay is a legitimate resurface and saves money. If the base has failed, an overlay just moves the failure up a layer and cracks again in a year or two. We check the base and tell you honestly, then quote a number that won’t change.
New asphalt paving runs $4,130 to $10,620 for a typical residential drive, a seal and resurface runs $295 to $825, and a full replacement sits between $5,900 and $16,520. Size, base condition, access, drainage, and permit scope move you within those ranges. Call (888) 427-1733 for an exact quote; estimates are free.
No, not on the scope we quote. The number you see is the number you pay, backed by our 730-Day Done Right Promise. If we find a failed subgrade after tear-out, we stop, show you, and quote the additional work before we do it. Call (888) 427-1733 to schedule your free on-site estimate.
Get a Free Asphalt Estimate for Your Los Angeles Driveway
We’ll come to your property, check the base, and hand you a line-itemed written estimate for Asphalt Driveways & Resurfacing in Los Angeles, at no charge. Call (888) 427-1733 and a live person answers, day or night. We’ll ask about your driveway, set a time, and you’ll know exactly what the job costs before you commit. From foundation to finish line, priced upfront and backed in writing.
Written by the team at Groundwork Construction Co.