Kitchen remodeling
Bathroom remodeling
Home additions & ADU
Roofing
Windows & doors
Driveway & pavers
FenceFree written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Door Installation in Manhattan Beach, CA: What It Takes and What It Costs
Door installation in Manhattan Beach typically runs $950 to $4,200 per door installed, with most single-door projects landing around $1,400 to $2,200 once trim, hardware, and finish work are factored in. A standard pre-hung interior or exterior door is a one-day job; a custom carriage-house or oversized entry with a smart opener can stretch to three days. Call (888) 427-1733 for a free on-site estimate and a written line-item quote.
How a Door Installation Actually Runs, Stage by Stage
We don’t treat a door as a hole to fill. Every stage below is a decision point, and we walk you through each one before the saw comes out.
Stage 1: Site measure and opening inspection (day 1, about 60 to 90 minutes). We pull measurements on the rough opening, check the wall for plumb and square, and confirm how the door ties to the structural framing. In the 1950s beach cottages still standing in Manhattan Beach, this is often where surprises surface: a header that’s sagged, or stucco that’s cracked at the corner from decades of marine-layer moisture. You decide nothing at this stage except whether to proceed. We decide what the opening needs before a new door goes in.
Stage 2: Demo and prep (day 1, two to four hours). The old door and frame come out, we clear the opening, and we address anything the inspection flagged. Rotted sill plates get replaced. We flash the exterior opening before the new unit goes in, which is the single step most crews skip and the one that decides whether you have a leak three winters from now. You review and approve any added scope before we start this stage.
Stage 3: Setting the door (day 1 to day 2, two to three hours). The new door goes into the rough opening, gets shimmed, leveled, and plumbed, then fastened. This is the hinge point (pun intended) where precision matters most. A door that’s off by an eighth of an inch will drag, fail to latch, or whistle in the onshore wind. We check operation at least three times before moving on.
Stage 4: Trim, hardware, and finish (day 2, three to five hours). Casing and trim go on, hardware gets mounted, and finish is applied. This is where you make the aesthetic calls, and you should make them in stage 1, not here. Stain color, paint or clear finish, hardware finish, and handle style all get locked in early so nothing delays this stage.
Stage 5: Seal, weatherstrip, and final inspection (day 2 to day 3, one to two hours). We seal the exterior perimeter, install weatherstripping and the threshold, and test the latch, deadbolt, and swing. You walk the job with us and sign off. Total for a standard exterior door: one to two days. Custom or oversized: up to three.
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
The Options You’ll Choose Between for Door Installation
Manhattan Beach buyers have real choices here, and the honest trade-offs matter more than a spec sheet suggests. Our windows & doors service covers the full opening, but here’s what actually changes a door decision:
- Fiberglass exterior doors. The best all-around choice for salt-adjacent streets. Fiberglass won’t corrode, won’t swell like wood, and holds a factory finish for years. Polyurethane-core fiberglass runs $350 to $1,100 for the slab; figure $1,200 to $2,400 installed.
- Wood doors and carriage-house styles. The architect-grade look that matches Manhattan Beach’s custom-build character. Real wood is beautiful and needs maintenance: reseal every two to three years in this climate, or it checks and splits. Expect $900 to $3,500 for the slab plus finishing time.
- Steel entry doors. Strong and secure, but a poor match for coastal air unless it’s stainless or marine-grade hardware. Rust shows up fast on cheaper galvanized fittings. $250 to $900 for the slab.
- Door hardware and fasteners. This is where the salt-laden air west of Highland punishes inland hardware. Specify stainless and marine-grade where it counts. Good hardware adds $200 to $600 and saves you replacement within a few years.
- Whisper-quiet openers and smart integration. For garage and entry doors requiring automation, quality openers (belt-drive or smart-home-integrated) add $350 to $900 and integrate with your existing setup. Cheap chain-drive openers are noisy; premium doors deserve better.
See the difference
Before
After
Before
After
Before
AfterWhat Door Installation Costs in Manhattan Beach, CA
Door installation in Manhattan Beach runs $950 to $4,200 per door installed, driven by the five variables below:
| Line item | Typical range |
|---|---|
| Interior door (slab + labor + trim) | $950 – $1,800 |
| Standard exterior door installed | $1,200 – $2,400 |
| Premium wood / carriage-house entry | $2,200 – $4,200 |
| Hardware upgrade (stainless/marine-grade) | $200 – $600 |
| Whisper-quiet or smart opener | $350 – $900 |
| Structural/framing repair (if needed) | $400 – $1,500 |
What moves the number: size and style (a standard 32-inch door sits at the low end; a 42-inch custom carriage door sits high), existing opening condition (rotted framing or a sagged header adds repair scope), material grade (fiberglass to architectural wood is a real spread), hardware spec (marine-grade adds cost but is worth it here), and permit scope (new openings or structural changes trigger a permit; a like-for-like swap usually doesn’t).
A written estimate from us itemizes the door unit, labor, trim, hardware, finishing, and any repairs, with nothing hidden. What it won’t include unless we flag it in advance: structural work inside the wall, or matching finish to an existing custom paint. Upfront pricing, no surprises.
What Manhattan Beach Homes Specifically Do to This Job
Manhattan Beach construction is dominated by teardown-and-rebuild custom single-family homes on small coastal lots, where strict coastal zoning (height limits, floor-area ratios, setbacks) collides with an affluent clientele that expects architect-grade finishes. That means the door work we do here is rarely incremental repair. It’s typically a full custom build or a gut remodel, and the door spec has to match a $2 million-plus house.
Salt air is the real adversary. On the sand-adjacent streets west of Highland and in the Gaslamp and Strand area, salt-laden air eats through galvanized fasteners, untreated steel hardware, and exterior fittings within a few years. We specify stainless and marine-grade materials most inland contractors never bother with. The surviving 1950s beach cottages on raised foundations often need framing and seismic upgrades before a new opening goes in. And winter storms expose poorly flashed openings fast, which is why we flash every exterior door before it goes in, no exceptions. If you’re planning a wider scope, this is often part of a full Windows & Doors in Manhattan Beach project, and we also handle Windows & Doors beyond the door itself.
Serving Manhattan Beach, CA – Our Local Coverage Area
We serve Manhattan Beach and nearby communities. Use the map below to see the area we cover. If you’re nearby, we can almost certainly help.
Frequently Asked – Door Installation in Manhattan Beach
A standard door install takes one to two days; custom or oversized doors take up to three. The timeline depends on opening condition and whether structural repairs are needed. Call (888) 427-1733 for an exact schedule after a site visit – estimates are free.
A like-for-like swap usually doesn’t require a permit, but a new opening or structural change does. We check what your specific scope triggers and pull the permits when needed. Call (888) 427-1733 to confirm your project’s requirements.
Yes – most door installations leave plumbing and structure untouched. We confine work to the opening and only touch framing when the existing opening is damaged. Call (888) 427-1733 for an assessment of your specific door location.
Door installation in Manhattan Beach runs $950 to $4,200 per door, with most jobs at $1,400 to $2,200. Size, material, hardware, and opening condition drive the spread. Call (888) 427-1733 for a written line-item quote – estimates are free.
Every door installation is backed by our 730-Day Done Right Promise – if it’s not done right, we make it right. That covers workmanship for two full years, one of the longest guarantees in the residential space. Call (888) 427-1733 with questions.
Homeowners in Manhattan Beach often pair a door project with exterior work like a Chain Link Fence in Manhattan Beach or a Vinyl Fence in Manhattan Beach to complete the property line. We also cover the full Manhattan Beach area, from the sand-adjacent streets west of Highland to the tree-lined blocks east of Sepulveda. If you’re comparing door systems, premium options from Cover and Andersen are worth a look for integrated smart-home hardware and factory finishes. Call (888) 427-1733 to schedule your free estimate.
Written by the team at Groundwork Construction Co.