Fence
Kitchen remodeling
Bathroom remodeling
Home additions & ADU
Roofing
Windows & doors
Driveway & paversFree written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Chain Link Fence in Manhattan Beach, CA: What It Costs and How Long It Takes
A chain link fence in Manhattan Beach typically runs $3,500 to $9,000, installed, for a standard residential lot line. Most jobs are finished in one to three days once materials are on site. The number moves with linear footage, height, gauge, gate count, and how much work the ground needs before posts go in. Coastal lots west of Highland add a wrinkle inland crews don’t deal with: salt air destroys cheap galvanized hardware in a few seasons. Call (888) 427-1733 for a free on-site estimate.
How We Build a Chain Link Fence in Manhattan Beach, Stage by Stage
The sequence matters more than most homeowners expect. A fence that leans or rusts out in five years is almost always a planning failure, not an installation one.
1. Site visit and layout (day 1, about 60 to 90 minutes)
We walk the property line with you, confirm where the fence actually goes, and check for the things that will wreck a post hole: irrigation lines, gas and water stubs, sewer laterals, and existing concrete. You decide the fence height, gate locations, and finish at this visit. On corner lots and tight coastal parcels, we also confirm the setback from the property line before anything is ordered.
2. Utility locate and permitting (day 1 to 5, depending on scope)
We call in the utility locate before digging. Fences under six feet generally don’t require a building permit in most California jurisdictions, but taller fences, fences on retaining walls, and anything touching a public right-of-way can trigger review. We handle the permit application and inspection scheduling when one is required. You don’t chase paperwork.
3. Demo and prep (day 2, half to full day)
Old fence comes out, posts and concrete included. This is where hidden costs live: a rotted wood post set in a 60-pound concrete plug takes real effort to remove. Brush and root clearing happens here too. For lots that turn out to need grading or a hard border under the fence line, homeowners often pair this with Concrete Driveways & Concrete Work in Manhattan Beach so both jobs share a single mobilization.
4. Post setting (day 2 or 3)
Line posts go in augered holes with concrete, terminal posts get bigger footings because they carry the tension of the whole run. Post spacing runs roughly 8 to 10 feet depending on height and wind load. On the sand-adjacent streets, we spec heavier terminal footings and stainless hardware from the start. Concrete needs to cure before the fabric goes on.
5. Fabric, gates, and walkthrough (day 3)
Top rail, tension wire, fabric, and gates go on, then we tension the run and check every gate swing. You walk the line with us before we leave. Anything that doesn’t sit right gets corrected on the spot, and the 730-Day Done Right Promise backs the work in writing after that.
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
The Options You’ll Choose Between Before We Order Anything
Chain link is not one product. These are the real decisions that change both the price and the useful life of the fence.
- Gauge: 11.5-gauge is the common residential spec and the sensible default. 9-gauge is noticeably heavier and stiffer, costs roughly 15 to 25 percent more in material, and suits long runs, dog containment, and anything that takes real abuse. 12.5-gauge is the budget option and dents easily.
- Coating: Plain galvanized is cheapest and will show surface rust within a few years near the beach. Vinyl-coated (typically green or black) lasts longer, looks quieter against landscaping, and adds a modest premium per foot. For Manhattan Beach salt exposure, we steer most clients toward coated fabric and stainless fasteners.
- Height: Four feet for a front-yard boundary, five feet for side and rear yards, six feet where privacy or a dog matters. Anything over six feet usually triggers permitting and wind-load review on an open-mesh fence.
- Gates: Walk gates and drive gates are priced per unit, not per foot. A double drive gate with a dropped center post or a caster setup costs meaningfully more than a single swing gate. Automated operators add further cost and are sometimes regulated by coastal setback rules.
- Top finish: A top rail with tension wire is standard. A tension-band top is stronger and pricier. Barbed or privacy inserts are options we’ll quote only where local rules allow them.
What a Chain Link Fence Costs in Manhattan Beach, CA
Expect $3,500 to $9,000 for a typical residential chain link fence in Manhattan Beach. Within that range, these are the variables that land a job at the low end versus the high end.
| Factor | Roughly how it moves the number |
|---|---|
| Linear footage | Most of the cost. A 100-foot run is far cheaper per foot than a 40-foot run with two gates. |
| Existing fence removal | Adds roughly $4 to $10 per foot when old concrete footings come out. |
| Gauge and coating | 9-gauge coated fabric over 11.5-gauge galvanized can push a job toward the top of the range. |
| Gates and hardware | A drive gate with operator and posts adds a real line item; a simple walk gate doesn’t. |
| Terrain and access | Sloped lots, tight side yards, and fence lines running through concrete all add labor. |
A written estimate from us lists posts, fabric, top rail, tension wire, gates, hardware, concrete, labor, and disposal as separate lines. What typically isn’t included unless we’ve agreed to it: landscaping restoration, sprinkler rerouting, and any work on a neighbor’s side of a shared line.
See the difference
Before
After
Before
After
Before
AfterWhat Manhattan Beach Homes Specifically Do to This Job
Manhattan Beach is a tear-down-and-rebuild town on small coastal lots, which changes the fencing conversation. You’re often fencing a property mid-construction or right after one, and the property line you’re fencing may not match the line you think it does. On lots where the original 1950s beach cottage has been replaced by a custom contemporary build, grading and drainage work often runs right along the fence line, and posts have to go in after that work is settled or the fence will move. Several of the custom builders we see locally, including Abodu and Mighty Buildings projects, plan fencing in the later stages for exactly that reason.
The salt air is the other factor. On the sand-adjacent streets and through the Gaslamp and Strand area, galvanized hardware and plain steel fasteners rust through in a few years, sometimes faster. We spec stainless hardware, coated fabric, and heavier terminal footings as the default for this side of town rather than an upgrade. Inland contractors rarely bother, and it shows within a season or two. One useful counterpart job: homeowners often pair fencing with Asphalt Driveways & Resurfacing in Manhattan Beach so the drive approach and fence work happen once, not twice. When this is part of a wider Fence Installation in Manhattan Beach plan across the property, we scope both together so gates and drive approaches line up. For the full scope of our Fence Installation work, that page covers the range of materials and yard setups. We handle this job across the Manhattan Beach service area and the ZIP codes 90266 and 90267.
Serving Manhattan Beach, CA – Our Local Coverage Area
We serve Manhattan Beach and nearby communities. Use the map below to see the area we cover. If you’re nearby, we can almost certainly help.
Frequently Asked – Chain Link Fence in Manhattan Beach
Most residential chain link fences in Manhattan Beach take one to three working days once materials arrive. Demo and post setting dominate the schedule, and concrete cure time is the reason a job doesn’t finish the same day it starts. Call (888) 427-1733 to get a schedule estimate for your lot.
Fences under six feet usually don’t require a building permit, but taller fences, fences on retaining walls, and fences touching public right-of-way can. We confirm the rule for your specific lot during the site visit and pull the permit if one applies. Call (888) 427-1733 and we’ll tell you where your project lands.
Chain link fence in Manhattan Beach runs $3,500 to $9,000 for a typical residential lot. The range reflects footage, gauge and coating, gate count, and how much demo the old fence requires. We give a written line-item estimate so you can see exactly what drives the number. Call (888) 427-1733 for an exact quote, and the estimate is free.
No. The number on our written estimate is the number you pay unless you change the scope, and we say so in writing. Hidden footings, unexpected utilities, or a last-minute gate addition would be priced before we proceed, never after. Call (888) 427-1733 with questions before the job and we’ll answer them.
Workmanship is covered by the 730-Day Done Right Promise, which is one of the longest workmanship guarantees in the residential construction space. If something we installed isn’t right, we make it right. Material warranties come from the manufacturer. Call (888) 427-1733 to talk through the details of your project.
Get a Free Chain Link Fence Estimate in Manhattan Beach
We’ll come out, walk the property line with you, and leave you with a written estimate that shows every line item. Calls are answered by a live person 24 hours a day, so you won’t land in voicemail. Reach us at (888) 427-1733 to schedule your free estimate, and we’ll tell you what your fence will actually cost before you commit to anything.
Written by the team at Groundwork Construction Co..