Kitchen remodeling
Bathroom remodeling
Home additions & ADU
Roofing
Windows & doors
Driveway & pavers
FenceFree written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Walk-In Showers & Shower Remodeling in Calabasas: What It Costs and How Long It Takes
Walk-In Showers & Shower Remodeling in Calabasas typically runs $9,000 – $28,000 for a full bathroom remodel, with a standalone walk-in shower installation landing at $4,500 – $12,000 and a shower replacement at $3,000 – $8,500. Most jobs take two to four weeks from demo to final glass, depending on whether we’re moving the drain or keeping the existing footprint. Call (888) 427-1733 for a free on-site estimate and a written line-item quote.
How a Calabasas Shower Remodel Actually Runs, Stage by Stage
We don’t hand you a folder and disappear. Here’s the real sequence, with the decisions you’ll make at each stage.
Stage 1: Site visit and scope lock (day 1, about 90 minutes)
We measure the existing pan and wall dimensions, check the drain location and slope, and open the valve wall to see what’s behind the tile. In a lot of the 1960s and 70s ranch homes off Old Topanga and Mulholland, that means finding original copper or galvanized supply lines and a cast-iron drain. You decide then whether we stay in the current footprint or relocate the drain and valve, which is the single biggest fork in the project. Both estimates come in writing the same day.
Stage 2: Demo and rough-in (days 2 through 4)
We protect the floor and remove the old tile, pan, and backer board, then pull the valve and drain to inspect. If the drain is off-center or the slope is wrong, we correct it now rather than bury a problem under new tile. Plumbing changes here need to match what your permit drawings show, so your earlier decision about relocation matters more than anything else at this point. Rough framing and blocking for a bench or grab bar go in during this window.
Stage 3: Inspection and waterproofing (days 5 and 6)
The rough plumbing gets inspected before anything closes. Then we install the waterproofing membrane, cement backer board, and a sloped mortar bed with a pre-slope under the pan. This is the stage that’s invisible for the next twenty years, and it’s the one that decides whether the shower leaks. We flood-test the pan before tile goes on.
Stage 4: Tile, glass, and fixtures (days 7 through 12)
Wall tile, floor tile, niche, and bench get set, then grout and cure. Frameless glass templating happens after tile so the panels fit the actual opening, not a drawing. You’ll have already chosen tile, grout color, and hardware finish at the design consult, so there’s no mid-job scramble. A typical Calabasas shower takes four to five working days of tile, plus a cure day.
Stage 5: Trim-out and walkthrough (days 13 and 14)
Showerhead, valve trim, drain cover, and glass install. We run the water, check the pan for standing water, and do a final walkthrough with you. If anything isn’t right, the 730-Day Done Right Promise covers the fix – if it’s not done right, we make it right.
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
The Options You’ll Choose Between
Every shower is a stack of decisions. Here’s the honest trade-off on each, so you know what you’re actually buying.
- Shower pan: acrylic vs. tiled mud bed. A pre-formed acrylic pan is faster, cheaper, and easier to clean, but it can flex underfoot and cracks show with age. A hot-mopped or Schluter-style tiled mud bed is more durable and gives you any size or shape, but adds roughly $800 – $2,000 in labor and requires correct slope to drain.
- Wall tile: ceramic vs. porcelain vs. natural stone. Ceramic keeps cost down and is fine for low-traffic showers. Porcelain handles moisture and freeze-thaw better and is the common upgrade. Natural stone (marble, travertine) looks great but needs sealing every year or two, and in Calabasas’s dry heat it can etch if you’re not disciplined about maintenance.
- Glass: framed vs. frameless. Framed glass is cheaper and easier to install. Frameless costs more but gives the open sightline that makes a small shower feel bigger – a real factor in the narrower master baths of older Calabasas ranch homes.
- Drain: center vs. linear. A center drain is simpler. A linear drain lets you use larger floor tile with a single slope plane, but adds cost and requires a pan built to accommodate it. A linear drain is an aesthetic and cleaning preference, not a durability requirement.
- Bench, niche, and grab bar blocking. These small additions cost $300 – $1,200 together but are hard to retrofit later. Decide now.
What Walk-In Showers & Shower Remodeling Costs in Calabasas, CA
The lead range for this job is $9,000 – $28,000 for a full bathroom remodel, and a standalone walk-in shower or shower replacement sits at $4,500 – $12,000. Four or five variables push a job to the low or high end:
| Factor | Drives the price |
|---|---|
| Footprint size | A 3×3 shower is at the low end; a 5×5 or larger custom shower pushes higher. |
| Plumbing relocation | Moving the drain or valve means new rough-in and often concrete or joist work. |
| Material grade | Porcelain and acrylic keep cost down; marble and custom glass raise it. |
| Existing condition | Rot, old galvanized lines, or a failed pan add demo and repair time. |
| Permit scope | A straight replacement may not need a permit; a layout change or plumbing move usually does. |
A written estimate from us covers demo, rough plumbing, waterproofing, tile, fixtures, glass, and permit fees if required. It doesn’t cover structural repairs found after demo – a rotted subfloor or joist is a change order you’ll see in writing before we proceed. Upfront pricing, no surprises: the number you see is the number you pay. Call (888) 427-1733 for an exact quote – estimates are free.
See the difference
Before
After
Before
After
Before
AfterWhat Calabasas Homes Specifically Do to This Job
Calabasas sits in the Santa Monica Mountains foothills, and that shapes the work. A lot of the homes we’re in off Mulholland Heights and in the canyon neighborhoods were built when cast-iron drains and galvanized supply lines were standard, so a “simple” shower swap often uncovers plumbing that’s reached the end of its life and needs replacing before the new pan goes down. The Mediterranean-style custom homes in The Oaks and Calabasas Hills tend to have larger master baths with more tile and more glass, which raises the material line but also gives room for a linear drain and a bench.
Fire safety is part of the conversation here too. Calabasas is in a Very High Fire Hazard Severity Zone, and post-Woolsey rebuilds in the canyons carry current WUI code expectations. A shower remodel doesn’t change your roof or siding, but if you’re touching venting or adding a skylight over the shower, the ignition-resistant details matter. Our teams have up to 12 years of experience and know how to sequence a permit through the city so inspections don’t stall the job. We cover all of Calabasas, including the 91302 and 91372 ZIP codes. If a larger master suite project comes up while we’re in there, that’s where our Bathroom Remodeling service and the full Bathroom Remodeling in Calabasas scope come in. Homeowners often pair this kind of work with Roof Replacement & Installation in Calabasas after fire-season concerns, or with Metal Roofing in Calabasas if they’re upgrading for the same reason.
Serving Calabasas, CA – Our Local Coverage Area
We serve Calabasas and nearby communities. Use the map below to see the area we cover. If you’re nearby, we can almost certainly help.
Frequently Asked: Walk-In Showers & Shower Remodeling in Calabasas
Most shower remodels take two to four weeks from demo to final glass, with a straight shower replacement running closer to one to two weeks. The timeline depends on whether plumbing moves, how much tile area you’re covering, and inspection scheduling. Call (888) 427-1733 to get a realistic schedule for your job.
A straight replacement in the same footprint often doesn’t require a permit, but moving plumbing, electrical, or the drain does, and structural changes always do. We pull the permits and handle the inspections so you’re not chasing the city. Call us for a free estimate and we’ll tell you exactly what your job needs.
Yes, and it’s usually the most cost-effective option – staying in the existing footprint keeps the job in the $4,500 – $12,000 range for a stand-alone shower. Relocating the drain or valve is the main driver of higher cost because it means new rough-in and inspection. Call (888) 427-1733 and we’ll walk your layout with you.
A full bathroom remodel in Calabasas runs $9,000 – $28,000, while a stand-alone walk-in shower or shower replacement is $4,500 – $12,000. Material grade, footprint size, plumbing changes, and permit scope move the number. Call (888) 427-1733 for an exact quote – estimates are free.
Every project is covered by our 730-Day Done Right Promise – if it’s not done right, we make it right. That’s one of the longest workmanship guarantees in the residential construction space, and it applies to the waterproofing, tile, and glass install. Call (888) 427-1733 for details or to schedule your estimate.
Get a Free Walk-In Shower Estimate in Calabasas
Call (888) 427-1733 to schedule a free on-site estimate for Walk-In Showers & Shower Remodeling in Calabasas. A live person answers around the clock, and we’ll walk your shower, take measurements, and hand you a written line-item quote the same day – with no-hassle upfront pricing, 0% financing for 18 months, and $1,000 off projects over $10,000. No voicemail, no waiting until Monday.
Written by the team at Groundwork Construction Co.