Driveway & pavers
Kitchen remodeling
Bathroom remodeling
Home additions & ADU
Roofing
Windows & doors
FenceFree written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Asphalt Driveways & Resurfacing in Calabasas: What It Costs and How Long It Takes
Asphalt Driveways & Resurfacing in Calabasas typically runs $3,500 – $9,000 for new asphalt paving, with most hillside driveways landing in the $5,500 – $8,000 range once grading and drainage are factored in. A straightforward resurface over sound base takes one to two days; a full tear-out and rebuild on a sloped canyon lot runs three to five days, plus cure time before you park on it. Call (888) 427-1733 and we’ll walk your driveway and give you a written number.
How We Build or Resurface an Asphalt Driveway, Stage by Stage
Asphalt work on a Calabasas lot is mostly prep. The blacktop itself goes down fast; everything that determines whether it lasts ten years or three happens before the paver shows up. Here’s the sequence.
- Site walk and drainage plan (day 1, about an hour). We measure the run, check the slope, look at where water currently exits, and note any oak canopy or root zones near the edges. On hillside lots the drainage decision gets made here, not later. You decide the layout and whether you’re resurfacing the existing footprint or widening it.
- Tear-out and base prep (day 1 – 2). We remove failed asphalt, rototill and recompact the subgrade, then lay and compact Class II base in lifts. On steep grades we cut a proper crown so water sheds to a swale or channel drain instead of pooling at the garage door. This is the stage where a two-day job becomes a four-day job: bad base is the single biggest driver of asphalt failure, and we don’t pave over it.
- Grading inspection and edge restraint (end of day 2). We set the grade so the finished surface sits at the right height against the garage slab and any adjacent hardscape, and install edge restraint so the asphalt doesn’t ravel at the borders. You confirm where the new apron meets the street.
- Paving (day 3, one long day). Hot-mix asphalt arrives, gets laid at 2 to 3 inches compacted for residential driveways, and rolls out to density. We hand-tamp the edges and any tight turns. You’ll see the finished surface by end of day, but you can’t drive on it yet.
- Cure and seal decision (days 3 – 30). Asphalt cures over roughly 30 days, and light foot traffic is fine after 24 to 48 hours while vehicles wait a few days longer, depending on weather. We schedule sealcoat for after the cure window rather than slapping it on wet asphalt. You decide whether to seal now or next season.
Where the wider project comes in: if the driveway is part of a full Driveway & Pavers in Calabasas plan that includes walkways or a patio, we sequence the asphalt first and the hardscape second so trucks aren’t rolling over fresh paving.
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
The Choices You’ll Actually Make on an Asphalt Driveway
Asphalt isn’t one product. The decisions here are about mix, thickness, finish, and whether you’re resurfacing or rebuilding, and each one changes the price and the lifespan.
- New asphalt vs. resurface. A resurface (an overlay over sound base) is the cheaper path, but it only works if the underlying base is intact. If you’ve got alligator cracking or rutting, an overlay just buys you a year. A rebuild costs more and lasts far longer.
- Mix grade. Standard hot-mix is what most residential driveways get. A polymer-modified mix holds up better to heat and turning loads, which matters on a sun-baked Calabasas drive, but it costs more per ton.
- Thickness. Two inches compacted is the residential standard; three inches is worth it on long, steep runs or where a heavy vehicle regularly turns around.
- Finish. Plain asphalt is the default. A sealcoat after cure gives a uniform black finish and helps with UV and oil resistance; it’s a maintenance item, not a permanent coating.
- Drainage and edge detail. Channel drains, swales, or a slight crown, plus edge restraint. On a slope this is not optional, and it’s often where the real money goes on a canyon-lot job.
- Apron and street interface. How the drive meets the curb or street matters for both drainage and any city inspection of the approach.
We keep our material suppliers to a curated list of brands we trust, the same approach we take from Driveway & Pavers through every trade we run, and that applies to the aggregate and mix we spec here.
What Asphalt Driveways & Resurfacing Costs in Calabasas, CA
Expect $3,500 – $9,000 for asphalt driveway paving in Calabasas, with a full build on a sloped canyon lot often landing in the $5,500 – $8,000 range. A straight resurface comes in lower; a rebuild with drainage work comes in higher.
What pushes a job to the low end versus the high end:
- Square footage. A standard two-car drive is one number; a long, curved hillside run with a turnaround is another.
- Existing condition. Resurfacing over sound base is the cheap path; failed base means tear-out, re-compaction, and new base, which is the biggest single cost swing.
- Slope and drainage. Grading, swales, and channel drains on a Calabasas canyon grade add real work that flat-lot paving never touches.
- Access. Tight driveways or lots where a truck can’t turn around add handling time and sometimes require a smaller, more expensive delivery.
- Permit scope. A simple resurface usually needs no permit; anything touching the street apron or altering drainage can pull the city in.
A written estimate from us itemizes tear-out, base, asphalt, drainage, and any permit line so the number you see is the number you pay. It typically does not include landscape repair around the edges or future sealcoating, which we quote separately when you’re ready.
See the difference
Before
After
Before
After
Before
AfterWhat Calabasas Homes Specifically Do to This Job
Calabasas is foothills and canyon country, and that shapes asphalt work here more than anything else. A lot of what we see sits on grade in The Oaks, Calabasas Hills, and the canyon roads off Mulholland, where a driveway is really a drainage structure first and a parking surface second. Hot, dry summers and Santa Ana wind events bake the surface and dry out the base, and winter rain on a sloped lot finds every weak spot. In the burned and denuded canyon areas, rain runoff and erosion control become part of the conversation before anyone paves. The City’s hillside and oak-tree rules matter too: if the drive edge runs near a protected coast live oak or its root zone, an arborist report and setbacks can reshape the whole plan, which is why we look at that on the site walk, not after demo. Our crews bring up to 12 years of experience with these sloped, sun-and-fire country driveways, and we work across Calabasas with that in mind. Homes here often pair driveway work with a New Detached ADU in Calabasas or a Junior ADU & Interior Conversion in Calabasas, and we sequence the site work so the paving doesn’t get torn up twice.
Serving Calabasas, CA – Our Local Coverage Area
We serve Calabasas and nearby communities. Use the map below to see the area we cover. If you’re nearby, we can almost certainly help.
Frequently Asked: Asphalt Driveways & Resurfacing in Calabasas
A resurface is typically one to two days; a full tear-out and rebuild on a hillside lot runs three to five days, plus about 30 days of cure before sealcoat. Call (888) 427-1733 for a timeline specific to your driveway.
Most pure resurfacing doesn’t require a permit, but anything that changes drainage, grading, or the street apron can pull the City in, especially on a sloped or oak-adjacent lot. We tell you exactly what’s needed at the estimate, and we pull what’s required and pass inspection.
Yes, if the base underneath is sound. We check for alligator cracking, rutting, and soft spots on the site walk; where the base is failing, an overlay just delays the problem, and we’ll tell you that straight. Call (888) 427-1733 and we’ll assess it.
Failed base, steep grading, drainage work, and tight access are the big movers, and they’re the reason a canyon-lot job can land near the top of the $3,500 – $9,000 range. Estimates are free, so call (888) 427-1733 for an exact number.
Every job is covered by our 730-Day Done Right Promise, one of the longest workmanship guarantees in residential construction: if it’s not done right, we make it right. Call (888) 427-1733 to schedule your free estimate.
Schedule Your Free Asphalt Driveway Estimate in Calabasas
Call (888) 427-1733 to schedule a free on-site estimate for Asphalt Driveways & Resurfacing in Calabasas. We’ll walk the driveway, check the base and drainage, and hand you a written, itemized quote with the number you see being the number you pay. A live person answers around the clock, and there are no surprises once work starts.
Written by the team at Groundwork Construction Co.