Windows & doors
Kitchen remodeling
Bathroom remodeling
Home additions & ADU
Roofing
Driveway & pavers
FenceFree written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Sliding & Patio Doors in Los Angeles: What the Job Actually Involves
Sliding and patio door replacement in Los Angeles usually runs $3,200 to $11,500 for a single opening, and a typical project takes one to three days on site once the unit is ordered and permits (if required) are in hand. The wide part of that range comes from size, glass package, frame material, and whether the opening has to change. Most Los Angeles homes we walk through need a straightforward swap; a smaller share need structural or header work that pushes the number up. Call (888) 427-1733 and we’ll give you a written, upfront number after seeing the opening.
From Measure to Final Seal: How We Run the Job
Sliding and patio door work has a predictable rhythm. Here’s the sequence, and where you make decisions.
Day 1 morning: measure and site check
We confirm the rough opening, check the sill for rot or settling, and look at how the header and adjacent stucco are holding up. On older Los Angeles bungalows, the sill is where we find the surprises: dried-out weatherstripping, cracked tracks, and occasionally a soft subfloor patch that has to be addressed before the new unit goes in. You decide here whether we’re keeping the existing opening size or resizing.
Day 1: order and permit
Once you pick frame material, glass package, and finish, we place the order. Lead times run two to six weeks depending on the brand and configuration. If the home is in a hillside fire zone or a historic overlay, we pull the permit before demo starts.
Day 2: demo and prep
Out comes the old slider. We protect the floor, remove trim and threshold, and inspect the framing. Any rot or anchor issues get corrected now, not later. This is the day you’ll want the room cleared and pets settled elsewhere.
Day 2 – 3: set, shim, seal
The new unit is set plumb, shimmed, and anchored. We flash the exterior, seal the interior, and check that the panel rolls smoothly and latches true. Glass comes with the manufacturer’s warranty; our workmanship is covered by the 730-Day Done Right Promise.
Day 3: trim and walkthrough
Interior trim goes back, the threshold is finished, and we walk the door with you. You sign off only when the operation is smooth and the seals are tight. If anything’s off, we fix it while we’re there.
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
The Options You’ll Choose Between
Sliding and patio doors aren’t all one product. Here’s the real trade-off list.
- Vinyl frames: The value pick. Good thermal performance, low maintenance, and the most affordable option. They can look a little flat against original stucco on a Spanish Colonial, though.
- Aluminum: Slim sightlines and strong frames, popular for modern remodels and larger openings. Aluminum conducts heat, so specify a thermally broken version if the door faces west.
- Wood and wood-clad: The best look on a 1920s Craftsman or a period home. Wood interiors, aluminum or vinyl cladding outside for weather resistance. Higher cost, but the profile matches the architecture.
- Glass package: Standard dual-pane is the baseline. Low-E coatings and argon fill make a measurable difference on a west- or south-facing door, which matters here more than most places.
- Configuration: Two-panel slider, three-panel, or a large multi-slide for an indoor-outdoor flow. Bigger panels mean bigger headers and more structural work.
- Screen and hardware: Retractable screens, heavy-duty rollers, and multi-point locks add cost but reduce the maintenance calls we get two or three years out.
What Sliding & Patio Doors Cost in Los Angeles, CA
Here’s the working range for a single opening, installed.
| Scope | Typical Range |
|---|---|
| Standard two-panel slider, vinyl, existing opening | $3,200 – $6,500 |
| Wood-clad or aluminum, mid-size opening | $5,500 – $9,000 |
| Large multi-slide or resized opening with header work | $9,000 – $11,500+ |
What pushes a job to the low end: existing opening is intact, stock size, vinyl frame, and a straightforward west-side install with no permit required. What pushes it up: resizing the opening (header and structural work), fire-zone or historic-district permit requirements, hillside access that requires more labor and staging time, and upgraded glass packages.
What’s included in a written estimate: labor, the unit, flashing, trim, interior and exterior seal, and cleanup. What typically isn’t: structural repairs discovered after demo, drywall patching beyond the immediate opening, and painting. We list those as separate lines so the number you see is the number you pay on the original scope.
See the difference
Before
After
Before
After
Before
AfterWhat Los Angeles Homes Specifically Do to This Job
Los Angeles construction is governed by some of the strictest seismic and fire-zone rules in the country, and that hits door work directly. If the opening needs a new header or the wall is load-bearing, the seismic detailing matters, and hillside homes often get extra scrutiny on header attachments and anchoring. In the hills, WUI fire code pushes toward ignition-resistant frames and tempered glass. The housing stock makes a difference too: 1920s-40s Craftsman bungalows in neighborhoods like Highland Park and Echo Park have non-standard rough openings that don’t match stock sizes, while postwar stucco tract homes in the Valley tend to be more predictable. In Natomas-adjacent flats and older corridors, we regularly see sill rot from years of pooled water. We cover the full slate of Los Angeles neighborhoods, from the beach side through the hills. Door work is often part of a broader scope, so it lands inside our Windows & Doors service, and many homeowners pair it with Windows & Doors in Los Angeles upgrades in the same visit. If we’re already staging material, Paver Driveways in Los Angeles and Fence Repair in Los Angeles are common add-ons homeowners ask about while we’re set up.
Serving Los Angeles, CA – Our Local Coverage Area
We serve Los Angeles and nearby communities. Use the map below to see the area we cover. If you’re nearby, we can almost certainly help.
Frequently Asked: Sliding & Patio Doors in Los Angeles
One to three days on site once the unit arrives. Order lead time is the bigger variable at two to six weeks. Call (888) 427-1733 for a schedule once we’ve looked at the opening.
A like-for-like replacement in the same opening usually doesn’t. Resizing the opening, cutting a new one, or work in a hillside fire zone or historic district does. We confirm requirements during the estimate and pull what’s needed.
Yes, in most cases. Standard replacement in the existing opening doesn’t touch plumbing. Resizing or relocating a door can trigger structural and sometimes plumbing work, which we scope upfront so there are no change-order surprises.
Most single openings land between $3,200 and $11,500 installed. Size, frame material, glass package, and structural work drive the range. Call (888) 427-1733 for an exact written estimate.
Every job is covered by the 730-Day Done Right Promise: if it’s not right, we make it right. The door unit carries its own manufacturer warranty, and our workmanship is backed in writing.
Get a Free Estimate for Sliding & Patio Doors in Los Angeles
If you’re pricing a slider or patio door, the first step is a walkthrough. We’ll measure, look at the sill and header, and hand you a written, line-item estimate with the variables spelled out so you know exactly where the number comes from. No obligation, no pressure. Call (888) 427-1733 and a live person will get you on the schedule.
Written by the team at Groundwork Construction Co.