Fence
Kitchen remodeling
Bathroom remodeling
Home additions & ADU
Roofing
Windows & doors
Driveway & paversFree written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Chain Link Fence in San Fernando, CA: What It Costs and How Long It Takes
A chain link fence in San Fernando typically runs $3500 – $9000, and most jobs are finished in one to three days on site. That range covers a standard residential run of 100 to 200 linear feet with posts, rails, tension wire, and a walk gate. Shorter runs come in closer to the bottom of the range; longer property lines with sloped grade and multiple gates climb toward the top. Call (888) 427-1733 for a free on-site estimate with a written, line-item price.
How a Chain Link Fence Goes In, Step by Step
Chain link is a fast job done right and a quick mess done wrong. Here’s the real sequence we run, and what you decide along the way.
Stage 1: Site walk and layout (1 – 2 hours). We mark the fence line with you, confirm property corners against your survey or plat, and decide where gates land. This is the stage where you tell us how the gate should swing and whether it needs to hold a lock. If there’s no recent survey, we flag it now rather than after posts go in. On tight mid-century lots this step decides more than people expect, because a foot in the wrong spot costs you a gate.
Stage 2: Locate and dig (same day). We call 811 for utility locates before anyone touches a shovel. Once marks are in, we auger post holes 24 to 36 inches deep, deeper on the corners and gate posts. On San Fernando properties with mature trees or older irrigation lines, we hand-dig the questionable holes. This is where a project either stays on schedule or stalls, so it comes first.
Stage 3: Set posts in concrete (day 1, then a cure). Line posts, corner posts, end posts, and gate posts go in with Sakrete concrete mix. Gate posts get a larger diameter and more concrete because they carry the swing load. The concrete cures overnight at minimum, and we don’t pull tension on the mesh until it’s set. Rushing this stage is the number one reason chain link sags inside a year.
Stage 4: Rails, mesh, and tension (day 2). Top rail goes up, then the mesh is stretched and tied off with tension bars at each end. We add tension wire along the bottom on runs over about 50 feet so a dog or a stray ball doesn’t lift the mesh off the ground. You’ll walk the line with us here and confirm gate swing and latch height.
Stage 5: Gates, hardware, and final walk (day 2 or 3). Gate frames hang, hinges and latches get set, and we clear the spoils. You get a walkthrough and the written workmanship coverage. Most San Fernando jobs of ordinary length close out on day two.
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
The Chain Link Options You’ll Actually Choose Between
None of these are exotic. Each one moves the price or the lifespan, so it’s worth picking deliberately.
- Gauge of mesh and wire: 11.5-gauge is the residential default and holds up fine. 9-gauge is heavier and resists bending from dogs and kids better, at a modest premium per foot. On a boundary line near a busy corridor, the heavier gauge earns its keep.
- Coating and finish: Galvanized is the honest budget choice and lasts well in dry Valley air. Vinyl-coated (usually green or black) costs more up front but looks less institutional and holds color through the UV. For a front-line fence visible from the street, coated is the usual pick.
- Post diameter and wall thickness: Standard residential is 1-5/8 inch posts. On longer spans, corners, and gate posts, going up a size prevents sag and swing drift. This is a quiet line item that separates a 15-year fence from a 25-year one.
- Height: 4 feet for a low garden boundary, 5 feet for most residential lines, 6 feet for privacy and dog containment. Above 6 feet usually means taller posts and more concrete, so price steps up.
- Gates: A single walk gate is standard. A double drive gate needs a heavier frame and better posts, and it’s a real jump in cost. Tell us up front if a vehicle entrance is part of the plan.
- Tension wire and bottom rail: A tension wire along the bottom is cheap insurance. A full bottom rail is sturdier and costs noticeably more, best for dog runs and sloped ground.
What a Chain Link Fence Costs in San Fernando, CA
Plan on $3500 – $9000 for a residential chain link fence in San Fernando. That’s the working range, and the line-item estimate tells you where in it your property lands. What moves the number:
- Linear footage. The biggest driver. At roughly $18 to $32 per foot installed, a 120-foot run and a 220-foot run are different projects.
- Grade and terrain. A flat backyard is straightforward. A sloped line needs stepped panels or racked rails, and that takes more labor and more posts.
- Gate count and type. Each walk gate adds cost; a drive gate adds more because the frame, posts, and hardware all change.
- Obstacles and access. Tight side yards, mature tree roots, old concrete to break out, and fences that run along an alley all add labor. If your lot backs onto a corridor, access equipment may be part of the price.
- Removal of an old fence. Hauling out a rusted chain link or a leaning wood fence is a real line item. Sometimes it’s worth it, sometimes left off the estimate and handled separately. We state it clearly either way.
A written estimate from us lists posts, rails, mesh, concrete, gates, hardware, removal, and any permit cost separately, so there’s no guessing what’s included. What usually isn’t included: grading or dirt work beyond setting posts, repairing a broken property-line dispute, and any utility relocation beyond the locate call.
See the difference
Before
After
Before
After
Before
AfterWhat San Fernando Homes Do to a Chain Link Fence Job
San Fernando is its own incorporated city with its own building department and plan check, which changes things for anyone used to LA County or City of LA parcels a few blocks away. Before we set a single post, we check whether your fence triggers a permit here: line-of-sight requirements at corner lots, height limits near the front setback, and any rules along an alley or corridor. Inspectors and plan checkers in a city about 2.5 square miles in size tend to know the local contractors, which cuts both ways. Do it right and it moves; cut a corner and it follows you.
The housing stock matters too. Much of what we fence here is postwar and early-1900s bungalows and small stucco homes on tight mid-century lots, and tight lots are the whole story on a chain link job. Side yards a few feet wide, shared property lines with a neighbor’s mature tree, and old concrete pads where a post wants to go. Between that and the Valley’s intense summer heat and UV, uncoated mesh and thin posts lose their finish and their shape faster than you’d expect. Our technicians have up to 12 years of experience reading exactly these conditions. We cover the whole city, both 91340 and 91341, and nearby areas through our San Fernando service area.
If the fence is one part of a bigger exterior project, it’s often more efficient to plan it as part of a full Fence Installation in San Fernando, and homeowners often pair a new fence with Concrete Driveways & Concrete Work in San Fernando or Asphalt Driveways & Resurfacing in San Fernando when the gate and the driveway are rebuilt together. You can see how our wider Fence Installation service handles the full range. Groundwork Construction Co. backs the work with our 730-Day Done Right Promise: if it’s not done right, we make it right.
Serving San Fernando, CA – Our Local Coverage Area
We serve San Fernando and nearby communities. Use the map below to see the area we cover. If you’re nearby, we can almost certainly help.
Frequently Asked, Chain Link Fence in San Fernando
Most residential chain link fences here take one to three days on site once work starts. Day one is layout, locate, digging, and setting posts in concrete; the concrete needs to cure before we stretch the mesh, so day two is rails, mesh, and gates. Longer runs, sloped lines, and drive gates push toward the third day. Call (888) 427-1733 for a free estimate with a realistic schedule for your property.
It depends on height, location, and whether the fence sits on a corner or near a front setback. Because San Fernando runs its own plan check and inspection rather than LA County or City of LA, we check your specific property against city rules before any post goes in, and we’ll tell you plainly whether a permit is needed and whether we’ll pull it. Call (888) 427-1733 and we’ll walk through your lot with you.
Yes, in most cases. We call 811 for utility locates before digging and hand-dig any hole near a marked line, irrigation, or mature tree root. We don’t grade or re-landscape your yard; we set posts, build the fence, and clear the spoils. If your lot has underground lines close to the fence line, tell us at the estimate and we’ll plan around them. Call (888) 427-1733 to talk it through.
Installed, chain link runs roughly $18 to $32 per foot here, which is why a typical residential job lands between $3500 and $9000. Gauge, coating, post size, height, gate count, and slope all move that per-foot number. Call (888) 427-1733 for an exact quote; estimates are free and come as a written breakdown.
Our work on the fence is covered by the 730-Day Done Right Promise, and the materials carry their manufacturer coverage on top of that. The promise is simple: if the installation isn’t done right, we come back and make it right. Call (888) 427-1733 to schedule a free estimate and we’ll spell out exactly what’s covered in writing before we start.
Get a Free Chain Link Fence Estimate in San Fernando
Call (888) 427-1733 to schedule a free on-site estimate for your chain link fence in San Fernando. A live person answers around the clock, and we’ll set a time to walk your property, measure the run, and hand you a written line-item price with no surprises. You’ll get the real number before you commit, plus respect for anything you’d rather not do day one. From foundation to finish line, built to last, backed in writing.
Written by the team at Groundwork Construction Co.