Kitchen remodeling
Bathroom remodeling
Home additions & ADU
Roofing
Windows & doors
Driveway & pavers
FenceFree written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Roof Replacement & Installation in Manhattan Beach, CA: What It Takes
Roof Replacement & Installation in Manhattan Beach, CA runs $8,000 to $20,000 for most homes, and a full tear-off and re-roof typically takes three to six working days, weather permitting. The number climbs when you’re matching architect-grade finishes on a custom build, stepping up to standing-seam metal ($15,000 – $40,000), or working tight on a small coastal lot. Call (888) 427-1733 for a free on-site estimate.
How a Manhattan Beach Roof Replacement Actually Runs, Stage by Stage
On day one we don’t touch a shingle until the roof is torn down to the deck and inspected. Demo of the old roofing, underlayment and flashing takes a day or so on a typical beach cottage. We then check the sheathing for rot, delamination and rusted fasteners. That’s when we find the damage salt air and winter storms have been hiding. You decide whether to replace the full deck or just the compromised sections.
Stage two is the structural correction. Older bungalows on raised foundations often have wavy sheathing or missing fascia from years of marine-layer moisture. We re-nail loose decking, replace rotten boards and square up the substrate so the new roof lies flat. This is the stage that quietly decides how good the finished roof looks, and it’s the one low bids skip. You approve any added structural scope in writing before we proceed.
Stage three is underlayment and ice-and-water shield. Along the coast, wind-driven rain finds its way under shingles at eaves and valleys, so we run a self-adhered waterproof membrane in those zones and a high-temp synthetic underlayment across the field. This is also where we flash penetrations, chimneys and skylights properly. Flashings are where most leaks start, and a good one outlasts the shingles around it.
Stage four is the finished roofing itself, installed over one to two days depending on material. Shingles go down fast; standing-seam metal or tile takes longer because of the panel work and the trim. We protect landscaping and windows, and we run a magnet sweep at the end of each day to catch stray fasteners around the yard and driveway.
Stage five is finish, flashing detail and inspection. We install ridge venting, seal the last penetrations, and walk the roof and gutters with you. If your project also touches exterior carpentry, doors or windows that weather at the same time, that’s a conversation we’ll have upfront so the schedule lines up with the rest of our Roofing in Manhattan Beach scope. Permits and a final inspection close out the job.
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
The Roof Spec Choices That Matter on a Coastal Custom Home
- Architectural asphalt shingles – the workhorse for a re-roof on a 1950s bungalow. A GAF or CertainTeed system fits the $8,000 – $20,000 range and holds up well under normal marine conditions. Trade-off: wind and salt wear shows sooner than on premium systems, so fastener quality matters more than homeowners expect.
- Standing-seam metal – the long-term pick for a custom contemporary build or a Strand-side home where you want to skip the next re-roof. It runs $15,000 – $40,000 and demands marine-grade fasteners and correct detailing. Trade-off: higher upfront cost and a look some prefer not to see on a beach cottage.
- Tile and specialty systems – a strong fit when the architecture calls for it and the weight is already accounted for in the structure. The realistic watch-out is a heavier system on an older raised-foundation home; the deck and framing need to carry it.
- Underlayment and flashing grade – this is where we spend beyond the cheapest bid. Synthetic underlayment, self-adhered membrane in valleys and eaves, and stainless or heavy-gauge flashing where salt air is active. It’s the difference between a roof that survives winter storms and one that leaks in year three.
We work with GAF and CertainTeed as roof partners, and match systems to your architecture rather than to whatever’s on sale. Built to last, backed in writing.
What Roof Replacement & Installation Costs in Manhattan Beach, CA
A standard roof replacement in Manhattan Beach runs $8,000 – $20,000. A full standing-seam metal system runs $15,000 – $40,000. A repair on an otherwise sound roof is a separate and much smaller job, $400 – $1,800, but this page is about the full replacement and installation scope. Here’s a line-item look:
| Item | Typical range (Manhattan Beach) |
|---|---|
| Full tear-off and re-roof (architectural shingle) | $8,000 – $20,000 |
| Standing-seam metal installation | $15,000 – $40,000 |
| Decking or sheathing replacement (per section) | Quoted as added line item |
| Flashing and penetration work | Included in roof scope |
| Permit and inspection fees | Passed through in writing |
What pushes a job to the low vs high end: roof size and pitch, the condition of the decking once it’s exposed, material grade, the amount of flashing and penetration detail on a custom build, and permit scope for a coastal property. A marine-grade fastener spec and proper underlayment cost more than a basic system and are worth every dollar here. Your written estimate is line-item, with no change orders on work we didn’t scope. Financing at 0% for 18 months is available, and projects over $10,000 take $1,000 off.
See the difference
Before
After
Before
After
Before
AfterWhat Manhattan Beach Homes Do to This Job Specifically
A lot of Manhattan Beach construction is teardown-and-rebuild custom single-family work, with strict coastal zoning, height limits and floor-area ratios shaping what actually gets built. That matters for a roof because the architectural spec typically follows the custom build: layered rooflines, complex valleys, and premiums where a simple re-roof wouldn’t fly. When the job is a scrape and rebuild, the roof is a true installation rather than a replacement, and flashing and detail work multiply.
The surviving older homes are mostly 1950s beach cottages and bungalows on raised foundations with stucco and wood-frame construction. On these we consistently find the same failure points: original 1x sheathing that’s softened from marine-layer humidity, and flashing at chimneys and valleys that’s failed quietly under winter storms. On the streets just west of Highland and around the Gaslamp and Strand areas, salt air eats through galvanized fasteners and standard exterior hardware, so we specify stainless and marine-grade fasteners as the default, not an upgrade.
Permitting runs through the city building department and gets stricter near the coastal zone, so we pull the permits and pass the inspections ourselves. We cover all of Manhattan Beach and the ZIP codes 90266 and 90267, and our Roofing service covers the same ground.
Serving Manhattan Beach, CA – Our Local Coverage Area
We serve Manhattan Beach and nearby communities. Use the map below to see the area we cover. If you’re nearby, we can almost certainly help.
Frequently Asked – Roof Replacement & Installation in Manhattan Beach
Most roof replacements in Manhattan Beach take three to six working days, weather permitting. A scrape-and-rebuild job with complex valleys and premium material runs longer because of the flashing detail and inspection schedule. Call (888) 427-1733 for a schedule on your specific home.
Yes, a roof replacement over an existing roof generally requires a permit in Manhattan Beach, and coastal-zone properties may need additional review. We pull the permits and pass the inspections for you, so the paperwork isn’t your problem. Call (888) 427-1733 to talk through what your property will need.
In most cases yes: a straightforward re-roof doesn’t touch framing or interior structure. But on older bungalows on raised foundations, exposed decking can reveal rot or wavy sheathing that needs correction first, and we’ll show you what’s there and quote it in writing before doing anything. Call (888) 427-1733 to schedule the inspection.
Most Manhattan Beach roof replacements fall between $8,000 and $20,000, with standing-seam metal at $15,000 – $40,000 depending on size and detail. Material grade, decking condition and flashing complexity are the biggest drivers. Call (888) 427-1733 for an exact quote; estimates are free.
Our work is covered by the 730-Day Done Right Promise: if it isn’t done right, we make it right. Manufacturer material warranties also apply on top, depending on the system you choose. Call (888) 427-1733 to talk through the coverage on your chosen roof.
Homeowners often pair a full roof with other exterior upgrades at the same time, including Door Installation in Manhattan Beach and Window Replacement in Manhattan Beach.
Schedule a Free Roof Replacement Estimate in Manhattan Beach
Call (888) 427-1733 to schedule a free on-site estimate for Roof Replacement & Installation in Manhattan Beach. We’ll come out, check the decking, look at your flashing and penetration points, and walk you through the material options with a written line-item number. The estimate and design consult are free, financing is available, and a live person answers the phone around the clock.
Written by the team at Groundwork Construction Co. of Los Angeles.