Fence
Kitchen remodeling
Bathroom remodeling
Home additions & ADU
Roofing
Windows & doors
Driveway & paversFree written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Wood Fence Installation in Los Angeles: What It Costs and How Long It Takes
A wood fence in Los Angeles, CA typically runs $4,130 to $10,620 for a standard residential run, and most jobs are built in two to four days on site. That number covers demolition of the old fence, post setting in concrete, framing, board installation, and a gate that actually latches. Heavier builds on acreage lots, taller privacy runs, and hillside spans with retaining work push toward the high end. Call (888) 427-1733 and we’ll price your exact footage against Los Angeles’s real material and permit costs rather than a per-foot guess.
This page is only about wood. If you’re weighing the whole project scope, our Fence Installation in Los Angeles page covers the broader picture, and our Fence Installation service hub lays out how we run the job from first measurement to cleanup.
How We Build a Wood Fence: Day One Through Final Walkthrough
Wood fencing fails on the parts you don’t see once the boards go up: post depth, concrete, and drainage. That’s why the sequence below matters more than the style you pick. Here’s exactly what happens and what you decide along the way.
Stage 1 – On-site measure and layout (about 90 minutes)
We walk the property line with you, measure total linear footage, and flag anything underground before a shovel touches dirt. In Los Angeles, that often means marking irrigation lines, pool bonding wire, and gas stubs before we set a single post. You decide gate placement and swing direction here, because moving a gate later means cutting framing and re-pouring.
Stage 2 – Demo and haul-off (half a day to a full day)
Old fence panels come down and existing post footings get dug out, not just sawed off at grade. Decayed posts left in the ground rot the new frame from below. On larger lots we haul off in a single trip, which is why heavier-duty equipment matters when the drive is long.
Stage 3 – Post setting (day one, plus curing time)
Posts go 24 to 36 inches deep in concrete, deeper on slopes and near grading. Concrete cures before framing starts, so this is the stage that sets your timeline. We don’t skip the cure to save a day, because a fence framed on green concrete leans within a season.
Stage 4 – Framing, boards, and gate (one to two days)
Rails, stringers, and pickets go up, then the gate is hung and adjusted for swing and latch alignment. You confirm board height and cap style before this stage so nothing gets reframed.
Stage 5 – Walkthrough and written sign-off (under an hour)
We walk the run, check every panel for plumb and spacing, and hand over the 730-Day Done Right Promise in writing. If a post shifts or a gate sags, you call and we make it right.
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
The Options You’ll Choose Between for a Wood Fence
Wood isn’t one product. These are the real forks in the road, with the honest trade-off on each.
- Cedar vs. pressure-treated pine: Cedar resists rot and insects naturally and looks better longer in Los Angeles’s dry heat, but it costs more. Treated pine is the budget choice and holds up fine when sealed every few years. For fire-zone parcels, cedar’s natural resistance is often the practical pick.
- Board-on-board vs. dog-ear pickets: Board-on-board gives full privacy and a cleaner look from both sides. Standard dog-ear pickets cost less and vent better, which matters on windy hillside runs.
- Post spacing and height: Standard 8-foot spacing with 6-foot boards is the baseline. Tighter spacing and 7 to 8-foot runs cost more but hold up far better in Santa Ana wind areas.
- Gate hardware: Self-closing hinges and a proper latch are worth the small upgrade. Cheap hardware is the number-one call-back on wood fence jobs.
- Finish: A penetrating stain adds years in this climate. Paint looks crisp but cracks in the heat and needs recoating.
What Wood Fence Costs in Los Angeles, CA
Plan for $4,130 to $10,620 on a typical residential wood fence in Los Angeles. That spread is wide because a few variables move the number hard.
- Linear footage and height: The primary driver. A short side-yard run sits near the low end; a full perimeter at 7 to 8 feet climbs toward the top.
- Material grade: Cedar and premium boards add cost over treated pine at the same footage.
- Terrain: Hillside and sloped lots need stepped panels and deeper posts, which adds labor.
- Demo and haul-off: Removing an old fence and its footings adds cost that a clean-lot install doesn’t carry.
- Permits and inspections: Height and setback rules in Los Angeles can require a permit, which adds a line item.
Your written estimate is line-item: footage, material grade, posts, concrete, gate, and permit scope. It doesn’t cover landscaping repair around the posts or hauling off soil unless we list it. Upfront pricing means the number you see is the number you pay, with no change orders mid-job.
See the difference
Before
After
Before
After
Before
AfterWhat Los Angeles Homes Specifically Do to This Job
Los Angeles construction answers to some of the strictest seismic and fire rules in the country, and fencing feels it. In the Hollywood Hills and Santa Monica Mountains, wildland-urban-interface fire code pushes homeowners toward ignition-resistant detailing and non-combustible gate hardware, and hillside grading rules mean fence posts on a slope often need engineering rather than a standard depth. On the flats – the 1920s-40s Spanish Colonial and Craftsman bungalows and the postwar stucco tracts – the hold-up is usually old footings and irrigation, not terrain. Out on acreage lots, the job is distance: long runs, detached workshops, and a single-trip build so the crew isn’t driving back for a forgotten gate hinge. We cover Los Angeles end to end, and homeowners often pair the fence with Paver Driveways in Los Angeles or Concrete Driveways & Concrete Work in Los Angeles to finish the front of the property in one pass.
Serving Los Angeles, CA – Our Local Coverage Area
We serve Los Angeles and nearby communities. Use the map below to see the area we cover. If you’re nearby, we can almost certainly help.
Frequently Asked – Wood Fence in Los Angeles
Most wood fence jobs in Los Angeles take two to four days on site, with concrete cure time built in. Larger acreage runs and hillside spans can stretch to a week. Call (888) 427-1733 for a timeline based on your footage.
It depends on height and location. Fences over the standard residential height, or on a corner or hillside lot with setback rules, can require a permit and inspection. We tell you up front whether yours needs one and pull it as part of the job.
No. Our written estimate is fixed based on the scope we measure and agree on. The number you see is the number you pay, which is why we mark underground utilities and confirm heights before the first post goes in.
Usually, yes. We remove old panels and footings carefully, but expect some landscaping repair directly around the post line. If you have irrigation or a paver border along the fence, tell us at the estimate so we plan around it.
Wood fence work is covered by our 730-Day Done Right Promise. If the build fails on workmanship, we make it right. Call (888) 427-1733 for a full written estimate with the warranty in writing.
Get a Free Wood Fence Estimate in Los Angeles
Call (888) 427-1733 for a free on-site estimate on your wood fence in Los Angeles. A live person answers around the clock – no voicemail, no waiting until Monday. On the call we take your footage and address, schedule a measurement, and send a line-item quote. Most projects over $10,000 qualify for $1,000 off, and 0% financing for 18 months is available. Estimates are free and there’s no obligation.
Written by the team at Groundwork Construction Co.